Temperature and brightness sensor user manual 2013-3-15 目录.
-
Upload
miles-thomas-douglas -
Category
Documents
-
view
304 -
download
0
Transcript of Temperature and brightness sensor user manual 2013-3-15 目录.
Temperature and brightness sensor user manual
2013-3-15
目录
catalogue
Sensor introduceDiagramSoftware introduction EnglishChinese VideoEnglish Video
Introduction about sensorThe sensor support brightness ,temperature, and humidity 。Dip switch setting(we default , temperature and brightness only) :No humidity : 11111001Contain humidity : 01111001
NO7 、 8 are for the speed :“ 00”is 0.5S ,“ 01”is 1S ,“ 10”is 10S ,“ 11”is 60S 。
COM connection way :One is DBT-Q9 male header ,another is 10PIN female pin header 。 DBT-Q9 use 2 、3 、 5pin , 10PIN use NO 5 、6 、 7pin ( the pin arrow header is NO10pin ), 7-3 ,6-2 , 5-5.
Dip switch
目录
Diagram 1
COM cable
Connect sensor
Power
目录
Diagram sensor between PC2
COM connector
Sensor header
目录
Software user info
Steps of setting temp and brightness Add temp and brightness data Fast set , revise temp, brightness para Others setting
目录
Temp and brightness set steps( 1 )
Open xmplayercontrol ->led control configure
目录
Temp and brightness set steps ( 2 )
Click to“para setting”,input password : dbstarled
目录
Temp and brightness set steps ( 3 )
Select the sending cardTick "data receive"Click “setup”
目录
Brightness setting steps ( 4 )tick“brightness auto adjust” ;“inspect port”item , choose“COM” ; tick“Already set on the basis of brightness adjustment”; Tick “debug” ;
目录
Temp and brightness set steps ( 5 )
Select the second sending card , the operation steps as steps4 。
目录
Temp and brightness set steps ( 6 )
•Select the sending card
目录
Add temp and brightness data( 1 )
new -> define led screenSet the screen sizeClick “OK”
目录
Add temp and brightness data ( 2 )
select“single child window”,user can select as your own requirements
目录
Add temp and brightness data ( 3 )
program routing->add ->inputdata
目录
Quick set , revise temp and brightness para ( 1 )
Click "quick set", ;Show the temp ,brightness, value ;Hide temp ,brightness name ;click“fonts”to change the font
目录
Quick set , revise temp and brightness para ( 2 )
Finished adjust , the right show temp, the left show brightness, may change with the environment changing
目录
Quick set , revise temp and brightness para ( 3 )
Click the quick set
目录
Other set ( 1 )
Control -> led controller configure
目录
Others set ( 2 )
Select the adjusted sending card ( USB )
目录
其他设置区域(三)单击“ brightness and color tone”
目录
Others set ( 4 )
You can set it directlyclick“OK”
目录
目录
目录