Automatic maintenance of a constant hot melt level in glue tankThe ‘meler’ automatic feeding system ensures continuous maintenance of a constant hot melt level in the glue tank, avoiding that way the manual refilling by the machine-operator.Every time that the tank sensor detects a low adhesive level, a signal is sent to the suction system, that then feeds a charge of pallets of hot melt directly from the adhesive bag or container to the glue tank. This charge is indicated by a lighting signal. When the sensor detects the correct hot-melt level, the transfer is stopped (you can program a delay time for disconnection).

Alarm SignalAn alarm signal, with a delay time since low level detection, advises of a possible failure in the transfer or an empty glue container or bag. An intermittent light and acustic alarm are activated simultaneously. The acustic signal can be interrupted pushing the corresponding button. Once the failure is corrected, you can reset the system by pressing the ‘RESET’ button.

Avoid hot-melt pollution and charThe system ensures a constant hot melt level in the tank avoiding a premature charring of the glue. Thanks to the completely closed transportation system the glue remains unpolluted (less cleaning maintenance) and you reduce the operations for the recharge of the system.

InstallationYou can install the system to all ‘meler’ systems and also to other systems. We supply the feeding system (control, filter, sensors and suction tube) together with the adaptor kit for the specific system. You can also order a 120L container for major autonomy of the gluing unit.

GLU

ING

SO

LUTI

ON

S

automatic feeding system

Constant hot melt level in the tank

Complete access to the electrical panel thanks to its lateral rotation system

The vibrator facilitates flow of adhesive

Tube length up to 20 meters (optional)

TECHNICAL CHARACTERISTICS

Type of adhesive ............................................................ pallets or perls up to 12 mmMaximum transfer length ............................................. 25 m (*)Maximum high difference for transfer ......................... 8 m (*)Maximum refilling speed .............................................. 400 kg/h (*)Standard dimension of tube .......................................... Ø30 mm x 4 mRecommended air supply ............................................. 6 bar (dry, clean and non lubricated air)Consumption at 6 bar .................................................... 360 l/min (during filling operation)System power supply .................................................... LN ~ 230V 50/60 Hz + PEContainer capacity ........................................................ 120 lMelter units ................................................................... all ‘meler’ rangeDimensions

Control box + filling entrance ................................... 190 x 290 x 210Suction tube .............................................................. 556 x 100 x 90

Filter .............................................................................. 20 mesh (< 1mm)

(*) Depending on type and shape of adhesive

Head OfficePol. Los Agustinos, c/G, nave D-43E-31160 Orcoyen - Navarra - SpainPhone: +34 948 351 110Fax: +34 948 351 130email: info@meler.es

www.meler.eu

GLUING SOLUTIONS

C 01

2 -

ENG

- V

0414

- M

ELER

rese

rves

the

righ

t to

mod

ify th

e co

nten

ts o

f thi

s ca

talo

gue

with

out n

otic

e.

Vibratory system for sticky granulate adhesives

Precise and reliable sensor Filter included to avoid dirty or dust emissions to ambient

Easy open tank lid for access with automatic switching-off