Step by step cleaning Computer “pc”

for

SAID ERNESTO RAMIREZ

1. We ensure that the tower be a completely disconnected socket.2. We put the safety features as masks, hat, with the help of screwdrivers we have to remove the screws from the back of the tower, in order to remove the cover.

3. In this step we place the antistatic bracelet to avoid small electric shocks to the board and thus not cause damage.4. After uncover, we have to disconnect all the cables coming from the power supply to the board, hard drive, DVD drive, and possible floppy drive or USB multi port.

5. In this step, we remove the DVD drive, hard drive, power supply. 6. Then remove RAM, processor heatsink, Possible network cards, or if the graphics card is embedded on the motherboard "board". And other belts as IDE or SATA'S.

6. Here we remove the board or motherboard, we left the box to perform free cleaning with blowtorch. 7. After blowing all parts carefully, clean the RAM memories with an eraser, apply contact the board clean and let dry 15 minutes.

8. While all dry, I took a picture to the keyboard and then we release all keys can leave them as we found them. 9. The keyboard can be disassembled and all plastic parts are washed with soap and water and using a small brush.

10. We then apply liquid sparkling in the monitor, tower tops, the mouse, to remove the dirt or dust that may have adhered.11. And to end apply silicone to plastic or metal as a monitor, keyboard, mouse and tower parts, proceed to install all the parts in place under the retired.

Finally we Our tower in optimal

terms.