IBM.actualTests.000 089.v2012!08!08.by.anonymous

IBM 000-089 System x Technical Fundamentals V11

Number: 000-089Passing Score: 800Time Limit: 120 minFile Version: 1.0

IBM 000-089

System x Technical Fundamentals V11

Version: 4.0IBM 000-089 Exam

Exam A

QUESTION 1IBM ToolsCenter Bootable Media Creator is used to create bootable media. Which of the followingfunctions can be performed with this tool?

A. Update firmware, update drivers, install Windows, report energy usageB. Update firmware, run diagnostics, install Windows, report energy usageC. Update firmware, update drivers, run diagnostics, install WindowsD. Update firmware, update drivers, run diagnostics, install Windows and Linux

Correct Answer: CSection: (none)Explanation

Explanation/Reference:Explanation:

QUESTION 2A customer asks for financial justification for the System x solution. Which resource can provide thecustomer requirements

A. AlineanB. TechlineC. CDATD. SSCT

Correct Answer: ASection: (none)Explanation


QUESTION 3A BladeCenter customer talks about UCS as a superior solution to their HS22 installation. Which of thefollowing is the competitor and a likely claim?

A. HP is going to stress easy cloud deploymentB. Dell is going to stress low purchase costC. Vblock is going to stress storage integrationD. Cisco is going to claim a completely unified system solution

Correct Answer: DSection: (none)Explanation


QUESTION 4An HP customer has is looking at IBM System x3850 eX5 servers, comparing them to the new HP DL580.Which of the following is a typical differentiator favoring the x3850?

A. Maximimum memoryB. Processor speedC. Intergrated quad port 1Gb EthernetD. More I/O slots available



QUESTION 5A customer has fully populated all the storage drive bays on an installed server. The customer plans to addnew storage and share storage with three other servers. Which of the following meets these requirements?

A. Replace current storage with solid state storageB. Add external storage via SANC. Add external storage via EXP2512D. Replace current storage with more dense drives

Correct Answer: BSection: (none)Explanation


QUESTION 6A customer recently purchased an HS23 blade to install into their existing BladeCenter H chassis. Thecustomer installed the blade and it was not recognized. Which of the following is the first question for thiscustomer?

A. What is the processor wattage?B. Is the AMM firmware up to date?C. Did they add the redundant AMM?D. Is the HS23 memory configuration optimized?



QUESTION 7A customer needs to get a working Windows 2008 image with drivers for their new servers as soon aspossible. Which of the following method would best achieve this?

A. Use ServerGuide to install Windows 2008B. Install Windows 2008 using the F6 supply Mass Storage Controller optionC. Deploy Customer existing image and use UXSPi to update IBM specific driversDeploy Customer?

existing image and use UXSPi to update IBM specific driversD. Replace Customer deployment solution with Tivoli Provisioning Manager for OS Deployment Director

EditionReplace Customer? deployment solution with Tivoli Provisioning Manager for OS DeploymentDirector Edition



QUESTION 8Which of the following System x products requires a TDA?

A. x3850 X5B. DS3500C. EXP2500D. x3690 eX5



QUESTION 9A customer is asking if the new IBM UEFI recognizes their Windows 2003 Enterprise Operating System.Which of the following is the correct answer?

A. UEFI can support Windows 2003 Enterprise in native modeB. An upgrade must be done to Windows 2008 Enterprise x64C. UEFI only supports Windows 2003 as a virtual machine guest (VMware or Hyper-V)D. UEFI can emulate BIOS and support Windows 2003 with no performance impact "Pass Any Exam. Any

Time." - www.actualtests.com 4 IBM 000-089 Exam



QUESTION 10After putting together a configuration that meets customer requirements, a TDA is suggested. Thecustomer is not familiar with the TDA processAfter putting together a configuration that meets customer?requirements, a TDA is suggested. The customer is not familiar with the TDA process and asks why thisshould be done. Which of the following is the benefit of a TDA?

A. A TDA brings an IBM technician onsite to properly inspect and installed hardware and related softwareB. A TDA will guarantee that the hardware will work in customer environment at the volumes projected.A

TDA will guarantee that the hardware will work in customer? environment at the volumes projected.C. TDAs are required only for IBM direct sourced business opportunities.D. A TDA will ensure the solutions and configurations are complete and technically sound.



QUESTION 11A customer plans to implement a shared storage solution. Cost is very important Which of the followingmeets these customer requirements

A. DS3500 with iSCSI attachB. DS3500 with fibre channel attachC. EXP2500D. Internal SAS drives



QUESTION 12A larger customer with locations world-wide needs to remotely update UEFI Firmware on their systems.Which function of IBM Systems Director will help this customer?

A. Update ManagerB. Automation ManagerC. Service and Support ManagerD. System Maintenance and Update Tool



QUESTION 13A customer is planning for a new large x3850 X5 server installation. Which of the following steps should betaken to ensure success?

A. Conduct TDA after installationB. Provide detailed TCO analysisC. Engage local FTSS for implementationD. Create a implemetation plan



QUESTION 14A System x technical specialist has a prospective customer who is excited about PureFlex and is workingon configurations for a large complex opportunity. During the engagement the customer has changed thedesign several times and has significantly increased the scope. What steps should the technical specialisttake to make sure the customer is satisfied with the solution?

A. Request Techline to perform an on site TDAB. Request Techline create configurationsC. Perform knowledge transfer of design requirements with the customerD. Engage Techline to assess configurations and assist in preparing for a TDA



QUESTION 15A retail customer has a database server that requires more than 64GB memory and more than

four processor sockets. Which of the following System x servers meets these requirements?

A. x3690 X5B. x3755 M3C. x3950 X5D. x3650 M4



QUESTION 16A customer is looking to build a new high performance computing environment. The customer wants anintegrated solution that offers a variety of choices for nodes, storage, and network. Which of the followingIBM solutions should a System x seller recommend that would be the meet all of the customerrequirements?Which of the following IBM solutions should a System x seller recommend that would be themeet all of the customer? requirements?

A. iDataPlexB. BladeCenterC. FlexSystem EntryD. IBM Intelligent Cluster



QUESTION 17A customer requests an HX5 blade with 256 GB memory, The customer is standardized on vSphere 5Enterprise Edition. VMware software licensing is a big concern. Which of the following is the minimumnumber of VMware licenses required?

A. FourB. OneC. TwoD. Three



QUESTION 18A prospective customer has iSCSI installed. The new project requires a large high performance storageand tape network. The customer does not appear to understand the terminology and options of the fiberchannel components of the solution. Further discussion confirms that the customer only has cursoryknowledge of Fiber Channel (FC) and is not currently prepared to for the installation. What steps should betaken to make sure the customer is satisfied with the solution?

A. Switch project to iSCSIB. Suggest a cloud networkC. Direct the customer to redbooks and white papers on FC technologies

D. Include services engagement to setup FC environment and perform knowledge transfer



QUESTION 19A customer needs the maximimum memory for their planned BladeCenter. Which of the following is themaximum amount of memory supported on IBM BladeCenter HS23?

A. 64GBB. 128GBC. 256GBD. 512GB



QUESTION 20A customer wants a blade server to run a very memory intensive application. They require 256GB withcapability to expand to 640 GB . Which of the following products supports this requirement?

A. HX5B. HS23C. HS22

D. HS22V



QUESTION 21A client is configuring an x3650 M4. Once the system is in production, they need to be able to remotelyview and make changes to the UEFI interface. Which of the following is the correct way to configure this?

A. Configure the CMM with an IP addressB. Configure the BMC with an IP addressC. Configure the IMM with an IP addressD. Configure the AMM with an IP address



QUESTION 22A System x 3550 customer is planning for RAID 6. Which of the following adapters meet this need?

A. M5100B. Converged network adapterC. Fibre Channel adapterD. M5115



QUESTION 23A System x technical professional is discussing the IBM x86 product family with a customer. The customeris very interested in PureFlex. Which resource should the technical specialist use?

A. Server Proven

B. SSCTC. Tiger TeamD. Competeline



QUESTION 24A prospective retail customer is considering a BladeCenter S with onboard storage. The customer requiresfour Ethernet connections. How many Ethernet module are required?

A. 1B. 2C. 3D. 7



QUESTION 25Which IBM Systems Director task will give you the ability to update firmware and device drivers on Systemx servers?

A. Update ManagerB. Virtual Media KeyC. Integrated Management Module (IMM)D. Tivoli Provisioning Manager for OS Deployment



QUESTION 26A customer who is reducing their technical staff has requested an Intel server proposal from variousvendors. Which of the following is most relevant to this proposal?

A. Remote KVMB. Grid ComputingC. Systems ManagementD. Advanced Energy Manager (AEM)



QUESTION 27A customer asks the System x technical specialist to advise them on updating their firmware during theinstallation of the new x3650 M4 servers. Which of the following provide that function?

A. SSCTB. Update ExpressC. CDATD. Server Guide



QUESTION 28A customer plans to implement a network of x3690 X5 servers. Which of the following tools would allowinstallation of firmware updates?

A. ToolsCenterB. VMware vSphere 5C. Tivoli Storage Manager (TSM)D. Tivoli Provisioning Manager (TPM)



QUESTION 29Which of the following is the maximum SAS raw storage capability of an x3550 M4

A. Three 3 TB drivesB. Eight 900 GB drives

C. Eight 1TB drivesD. Eight 3TB drives



QUESTION 30A customer plans to replace a large group of older 1U servers, each dedicated to a unique application.Fewer servers, and quick provisioning of those servers is important to the customer.Which of the following addresses this situation?

A. Move to X5 servers with IBM Systems DirectorB. Implement BladeCenter and VMwareC. Upgrade the 1U servers to improve performanceD. Replace each 1U server with energy efficient servers



QUESTION 31A customer purchases a virtual media key on an installed x3650 M3. The customer asks where to installthe key. Which of the following provides this information?

A. xREFB. COGC. ServerGuide Hardware ReferenceD. Problem Determination and Service Guide



QUESTION 32A toy manufacturing customer wants to run Microsoft SQL Server. Which category is applicable for such asolution?

A. E-mailB. DatabaseC. Network InfrastructureD. Systems Management



QUESTION 33A small business customer is interested in blades and requires shared storage. The customer will start withthree or four blades, but will grow and requires 4TB RAID 1+0 storage. They also require FlashCopy andRemote Mirroring and favor blades for future growth. Which solution can meet these requirements?

A. BladeCenter E with two FC switches, and two DS3500B. BladeCenter H with FC switch modules, DS3400 with 12x 750GB SATA HDDsC. BladeCenter S with FC Switch modules, DS3400 with 12x 750GB SATA HDDsD. BladeCenter S with RAIDed SAS Switch Modules, and, 12x 750GB NL SAS HDDs



QUESTION 34A customer has requested five rack mounted servers, and a rack. They want redundant powerconnections. Which of the following is required to meet these requirements?

A. Redundant PDUs in the rackB. Redundant power supplies in the serversC. Redundant power supplies in the servers and redundant PDUs in the rackD. Redundant power supplies in the servers, redundant PDUs in the rack, and Active Energy Manager

(AEM)



QUESTION 35A manufacturing customer wants a consolidation solution that provides scale-out capability and the highestprocessor density per rack unit. Which of the following solutions meets the customer requirements?

A. x3850 X5 with VMwareB. BladeCenter HT with VMwareC. BladeCenter HS23 with VMwareD. x3650 M4 with Microsoft Virtual Server



QUESTION 36A customer recently purchased a new x3550 M4 server and one of the hard drives has reported as failed.The customer is under standard warranty. They called the technical specialist asking for a replacement.Which action should the technical specialist recommed the customer take?

A. Contact IBM Technical Specialist to install a new driveB. Order a replacement drive with installation instructionsC. Contact the IBM CTS to replace the driveD. Contact the IBM Service and Support Center to analyse and solve the problem



QUESTION 37A customer purchased and x3650 M4 server and requires the ability to remotely power on and off theserver. Which of the following would the customer use to remotely power the server on and off?

A. UEFIB. Chassis Management Module (CMM)C. Integrated Management Module (IMM)D. Advanced Management Module (AMM)



QUESTION 38Which of the following blade servers offer hot swap internal hard drives?

A. HX5B. HS21C. HS23D. HS22V



QUESTION 39A customer has asked you to investigate their current x86 server environment to determine if they canachieve a reduction in power and rack consumption. They plan to implement VMware and shared storage.Which of the following consolidation proposals meets these needs?

A. BladeCenter SB. BladeCenter HC. BladeCenter ED. BladeCenter HT



IBM.actualTests.000 089.v2012!08!08.by.anonymous

Documents

Transcript of IBM.actualTests.000 089.v2012!08!08.by.anonymous