This Auto Dialer is a single channel voice dialer that can be used with any device that can provide a normally open or normally closed contact. The Auto Dialer can be programmed to store up to four numbers to dial, including standard (voice) telephones, most cellular telephones, and pagers. The Auto Dialer will deliver a recorded message for up to 16 seconds.

Auto Dialer Installation Instructions

Note: These instructions are intended as a quick reference for the most common installation of the Auto Di-aler when used with a control panel. For complete instructions, see the included Installation and Instruction Manual for the Automatic Voice Dialer. Before beginning installation, read the entire instruction manual for the AVD-45c Automatic Voice Dialer. For specific questions or problems please call SJE-Rhombus Technical

Support at 1-800-RHOMBUS, Monday – Friday 7:00 AM – 6:00 PM, CT.

PROGRAMMING TIPS 1. When programming for pagers, call the desired pager from the

telephone number and telephone line that the Auto Dialer will be attached to. Record the time required for the pager service to answer. Use that time for programming the required number of pauses needed. Each pause is two seconds in length.

2. If a cell phone does not ring before the Auto Dialer hangs up, program the cell phone number into the Auto Dialer with pauses after the number. Note: The number of pauses will depend on each cell phone and must be tested.

3. If a delay is desired before the Auto Dialer calls out to help prevent nuisance calls, set the entry delay to "on" and the channel to "continuous" mode. This will require that channel activation to be tripped for 20 seconds before dialing out and remain activated throughout the dialing process.

TESTING THE AUTO DIALER 1. Allpeopleororganizationsshouldbenotifiedthattheautodialer

will be calling and the action you would like them to take. 2. Apply power to the unit. 3. Be sure an active telephone line and all wiring is connected to the

auto dialer. 4. Press the "M" key until "Operate" appears in the LCD. 5. Trigger the signaling device to cause the auto dialer to call out. 6. The auto dialer will dial the numbers stored in locations 1-4. The

out going message will be delivered when the auto dialer receives an answer. For pager numbers, the pager code will be transmitted instead of the outgoing message.

7. The auto dialer is now ready for operation. 8. Test the Auto Dialer system once a month to insure the outgoing

message is being sent and received.

22650 County Highway 6 n P.O. Box 1708 n Detroit Lakes, Minnesota 56502 USA1-888-DIAL-SJE (1-888-342-5753) n Phone: 218-847-1317 n Fax: 218-847-4617 n E-mail: customer.service@sjerhombus.com

3. Connect the power cord, tele-phone line and alarm cable. It is ok to use your own telephone cable.

6. For programming refer to manual.

2. Determine indoor mounting location. If installing on wall, use the two screws and place parallel 5 3/16" apart.

5. If desired, install a 9V battery for battery backup, and plug in unit.

1. Verify all components are supplied; AVD-45c, power supply, screws, alarm cable, phone cable and manual.

4. Connect yellow and white wires from the alarm cable to the control panel N.O. or N.C. alarm contact.

NOTICE!Products returned must be cleaned, sanitized, or decontaminated as necessary prior to shipment to ensure that employees

will not be exposed to health hazards in handling said material. All applicable laws and regulations shall apply.

The Auto Dialer has the ability to send text, voice and email notifications through Google Voice! For detailed Google setup instructions please visit www.unitedsecurity.com/dialerinstructions.

7. Create a Google account at www.google.com.

9. Setup your Google Voice number to use with the SJE-Rhombus auto dialer.

8. Sign up for a Google Voice phone number.

10. Installation complete! Please visit www.sjerhombus.com for information on all of our products.

©SJE-Rhombus 05/16Instl Instr. PN 1012018E

SJE-RHOMBUS® warrants to the original consumer that this prod-uctshallbefreeofmanufacturingdefectsforfiveyearsafterthedate of consumer purchase. During that time period and subject to the conditions set forth below, SJE-RHOMBUS® will repair or replace, for the original consumer, any component which proves to be defective due to defective materials or workmanship of SJE-RHOMBUS®.

ELECTRICAL WIRING AND SERVICING OF THIS PRODUCT MUST BE PERFORMED BY A LICENSED ELECTRICIAN.

THIS WARRANTY DOES NOT APPLY: (A) to damage due to lightning or conditions beyond the control of SJE-RHOMBUS®; (B) to defects or malfunctions resulting from failure to properly install, operate or maintain the unit in accordance with printed instructions provided; (C) to failures resulting from abuse, misuse, accident, or negligence; (D) to units which are not installed in accordance with applicable local codes, ordinances, or accepted trade practices, and (E)tounitsrepairedand/ormodifiedwithoutpriorauthorizationfrom SJE-RHOMBUS®.

Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

TO OBTAIN WARRANTY SERVICE: The consumer shall assume all responsibility and expense for removal, reinstallation, and freight. Any item to be repaired or replaced under this warranty must be returned to SJE-RHOMBUS®, or such place as designated by SJE-RHOMBUS®.

ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FIT-NESS ARE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. SJE-RHOMBUS® SHALL NOT, IN ANY MANNER, BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES AS A RESULT OF A BREACH OF THIS WRITTEN WARRANTY OR ANY IMPLIED WARRANTY.

SJE-Rhombus® Five-Year Limited Warranty