Post on 07-Aug-2015
Impro Uniscan and
Flexiscan Range
Cost Effective Keyless
Access Control Solution
about US
Quad Transmitter SKA UniScan FlexiScan RF Receiver
Scan Range Features
about US
Common Features
• Supports 99 Tag holders• Up to 150m from Controller to Reader• Simple to configure using buttons on the controller• Support configuration lock using button pattern code• Support 125 kHz Passive Tags or Pin-code & 4 button RF Transmitter • Each Relay can be set to Toggled or Pulse mode• Hardware uses Impro’s proprietary S-bus protocol which comes standard with AES 128 bit encryption with key exchange
UniScan• Offers 1 door control through the single relay on the
Controller• Supports a single RF or Proximity reader• System is supplied as a kit with the UniScan Controller + the
selected reader
FlexiScan• Offers up to 4 door control using either the relays located on
the Controller or using remote relay units• Supports up to 8 RF and/or Proximity readers to control the 4
doors• The system is supplied as individual units
Scan Range Controller Overview
Input
S-Bus
Power Out
Relay 1
Relay 2
Relay 3
Relay 4
Configuration Buttons
7 Segment Display
FlexiScan Controller only
Scan Range Reader Overview
about US
SKA
RF Receiver
Proximity Reader• Standard with support for 125kHz EM4100 tags and PIN codes• Uses S-Bus protocol allowing installation up to 150m from the controller• Bi-coloured LED for access allowed/denied indication• The unit is addressable using on-board DIP switch• Rated at IP54 for outdoor applications
RF Receiver• 433MHz Receiver for use with the Impro 4 button RF tag• Uses S-Bus protocol allowing installation up to 150m from the controller• Standard with Impro’s Dynamic Code Transmission (DCT) technology • The unit is addressable using on-board DIP switch• The PCB is conformally coated for outdoor applications• The PCB has on-board signal strength indicators for infield range testing
Scan Range Remote Relay Overview
Remote Relay
Remote Relay• Standard with 1 x 10amp Relay and 1 x RTE input• Uses S-Bus protocol allowing installation up to 150m from the controller• Requires a 2 wire comms bus and operates at 12VDC• Is compatible with both the UniScan and FlexiScan Controllers • The unit is addressable using on-board DIP switch• The PCB is conformally coated for outdoor applications
UniScan – System Architecture
433 MHzRF Receiver
125 kHzProximity or
PIN
150m
UniScan Controller
OptionalRemote Relay
UniScan Architecture• The UniScan Controller supports a maximum of 1 reader• System is delivered as a package with the Controller and either the Proximity or RF receiver• The Remote Relay is an optional extra used when the physical constraints of the installation do
not allow the Controller relay to be used.
Relay
Flexi-Scan – System Architecture
about US
Relay
Relay
Relay Relay
Relay
S-Bus
125 kHzProximity or PIN
125 kHzProximity or PIN
433 MHzRF Receiver
Relay
Relay
125 kHzProximity or PIN
125 kHzProximity or PIN
FlexiScan Controller
FlexiScan Architecture• The FlexiScan Controller supports a maximum of 8
readers and 4 Remote Relay units for controlling up to 4 doors
• The FlexiScan Controller can support both RF and Proximity readers on the same system
• The addressing on the hardware allows readers to be linked to relays on the Controller and Remote Relays.• Readers set to address 1 will drive relay 1 on the
Controller and the relay on the Remote Relay set to 1
Scan Range – System Configuration
System Configuration• The system is completely configured on the Controller. No need for a PC
or software• There are 4 configuration buttons, 2 for location selection and an “Add”
and “Delete” button.• The system allows the simple addition of a Proximity tag, PIN code or RF
tag into the system using these four buttons.• There are 99 tag holder positions that can be configured per Controller.
• Any of the supported tags can be added or deleted for each location
• When the 4 button RF transmitter is used each button can be added or deleted per location and each button drives a relay. Button 1 drives relay 1, button 2 drives relay 2, etc.
• Relays can be set to toggled or pulsed mode• All tags added get 24/7 all access rights for easy of use
Configuration Buttons
7 Segment Display