SECTION 307-05 Automatic Transaxle/Transmission External...
Transcript of SECTION 307-05 Automatic Transaxle/Transmission External...
SECTION 307-05 Automatic Transaxle/Transmission External Controls
CONTENTS PAGE
Selector Lever Knob ........................................................................................................................................................... 307-05-2
307-05-i Automatic Transaxle/Transmission External Controls 307-05-i
2011 Mustang, 2/2011
Selector Lever KnobRemoval
NOTE: Click here or refer to the on-line Workshop Manual to view this illustration as an interactive exploded view, requires Adobe® Acrobat® 8.0 or higher.
NOTE: Click here or refer to the on-line Workshop Manual to learn about using an Interactive Illustration.
Item Part Number Description
1 W701894 Selector lever knob screws (2 required)
2 7213 Selector lever knob
3 — Selector lever knob shroud (part of 7213)
4 7210 Selector lever assembly
1. Remove the selector lever. For additional information, refer to Selector Lever in this section.
2. Disconnect the Transmission Control Switch (TCS) electrical connector.
3. Using a suitable tool, carefully pry the selector lever knob shroud down.
307-05-2 Automatic Transaxle/Transmission External Controls 307-05-2
2011 Mustang, 2/2011
4. NOTE: LH shown, RH similar.
With the selector lever knob shroud down, remove the 2 selector lever knob screws.
5. Remove the selector lever knob and shroud from the selector shaft.
Installation1. Route the TCS wiring through the selector knob shroud and selector lever.
1 Position the TCS wire towards the back right corner of the selector knob shroud.
2 Route the TCS wire through the selector lever opening.
2. NOTE: Keep the TCS wire taught while installing the selector lever knob.
Install the selector lever knob.
307-05-3 Automatic Transaxle/Transmission External Controls 307-05-3(Continued)
2011 Mustang, 2/2011
3. NOTICE: Tightening the transmission selector lever knob screws over 2 Nm (18 lb-in) may damage the selector lever assembly.
Align the transmission selector lever knob base screw hole with the selector shaft and install the selector lever knob screws.
• Tighten to 2 Nm (18 lb-in).
4. Slide the selector lever knob shroud up and snap into position.
5. NOTE: Make sure the TCS wire is pulled taught prior to connecting the TCS.
Connect the Transmission Control Switch (TCS) electrical connector.
307-05-4 Automatic Transaxle/Transmission External Controls 307-05-4(Continued)
2011 Mustang, 2/2011
6. Install the selector lever. For additional information, refer to Selector Lever in this section.
307-05-5 Automatic Transaxle/Transmission External Controls 307-05-5(Continued)
2011 Mustang, 2/2011