Author Wielder D. Catapat

A

BC

D

E

FG E

H

J I

KR L

SO

P M1 M2

Q N

QUICK START GUIDE AUDIO MIXER (AZDEN FMX 42u)

1. Remove the battery compartment cover (A) of the mixer and insert 6 pieces AA batteries. Check the correct polarity.

2. Connect the Boom Microphone to CH 1 (B) 3. Connect the Wireless Microphone or 2nd microphone to CH 2 if there is any (C)

Check the settings of your wireless system (Frequency, Audio Gain) 4. Turn ON the Mixer (D) 5. Set the INPUT LEVEL (PRE-AMP ATTENUATOR) (E) to MIC LO (max -15 dBu). You can switch

it to MIC HI (F) (max +4 dBu) if the microphone pick up is too hot and your meter is clipping. Set to LINE (G) if the audio signal is coming out from CD, iPod, Phone, etc.

6. Turn on the Phantom Power (H) if the microphone requires it. 7. HPF (I): 100 Hz 8. LIMITER (J): IN (input signal) 9. PAN (K). 10. Set the master fader (L) to 0(zero) 11. Connect the Mixer OUTPUT L\R (M1\M2) to your recording device or camera input. 12. Switch the output of the mixer to LINE/MIC (N) 13. Set the level of your recording device by sending the reference tone (O) from your mixer. Set

the acceptable level on your recording device. 14. Connect your Headphone (P) and adjust the volume accordingly. (Q) 15. Adjust your input GAIN (R) accordingly by monitoring the audio level from your mixer’s VU

meter. (S)