Manual MI6160 (ing)

1
Installation Diagram for SWK + USB Interface + VK-30C Dinacell Electrónica,S.L. Pol.Ind. Santa Ana C/ Torno,Nº 8 - 28522 Rivas - VaciaMadrid (Madrid) Spain Tel.: +34 91 3001435 Fax: +34 91 3001645 URL: www.dinacell.com e-mail: [email protected] 1. Connect the sensors to the USB interface. 2. Install the sensors on the ropes. 3. Connect the USB interface to the controller according to the wiring colour code (see the table below). 4. Follow the instructions manual of the controller for calibration. CONNECTION Colour Code for the standard 5 wires connection Excitation (+) RED Excitation (-) BLACK Signal (+) GREEN Signal (-) WHITE SCREEN SCREEN Installation of the sensor on the rope with a standard tool (a) or our special SW tool (b). a b Ref. 6160-00 08/06/2012

description

Manual el equipo MI6160 en formato pdf (idioma:inglés)

Transcript of Manual MI6160 (ing)

Installation Diagram for

SWK + USB Interface + VK-30C

Dinacell Electrónica,S.L. Pol.Ind. Santa Ana C/ Torno,Nº 8 - 28522 Rivas - VaciaMadrid (Madrid) Spain Tel.: +34 91 3001435 Fax: +34 91 3001645 URL: www.dinacell.com e-mail: [email protected]

1. Connect the sensors to the USB interface. 2. Install the sensors on the ropes. 3. Connect the USB interface to the controller

according to the wiring colour code (see the table below).

4. Follow the instructions manual of the controller for calibration.

CONNECTION

Colour Code for the standard 5 wires connection

Excitation (+) RED

Excitation (-) BLACK

Signal (+) GREEN

Signal (-) WHITE

SCREEN SCREEN

Installation of the sensor on the rope with a standard tool (a) or our special SW tool (b).

a

b

Ref. 6160-00

08/06/2012