MAKE 11 ROBOT C - Minnesota State University Moorheadweb.mnstate.edu/lindaas/explore/docs/Make 11b...
Transcript of MAKE 11 ROBOT C - Minnesota State University Moorheadweb.mnstate.edu/lindaas/explore/docs/Make 11b...
MAKE 11 ROBOT CHASSIS
Anthony Woltman © (2015) 1
Step 0: Solder wires to motors (if not already attached). Strain relief the wires. Review soldering tips as needed.
Step 1: Connect motor mounts to motors via screws.
Step 2: Remove protective paper from the acrylic
Step 3. Attach motors to acrylic via screws
.
Hint-‐ figure out where you want the motor cables to reach
Hint-‐ slowly screw both screws into mount. Avoid screwing one at a time.
MAKE 11 ROBOT CHASSIS
Anthony Woltman © (2015) 2
Step 4: Attach spacers to wheel
Step 5. Attach wheel to the acrylic. Add tires to the motors
Hint-‐ battery pack has to be attached someplace that it does not “tip” the robot.