LIT1998 G360 Super Fast Compound fact sheet A4 EN AUG ......AIR FLOW Remove P1500 sanding marks,...
Transcript of LIT1998 G360 Super Fast Compound fact sheet A4 EN AUG ......AIR FLOW Remove P1500 sanding marks,...
Farécla Products Ltd | +44 (0) 1920 465 041 | [email protected] | www.farecla.com
LIT1
998
(V1
08-2
018)
SUPER FAST CUT Unique abrasive technnology that contains no �llers or silicones, removing P1500 sanding marks permanently
TRANSPARENT IN USE Unlike P3000 which can mask P1500 process marks, G360 is transparent in use, allowing the operator to see the sanding marks being removed
NO P3000 REQUIRED Super fast results on P1500 sanding marks, eliminating the need for expensive and time consuming P3000 abrasive discs
FEWER PRODUCTS Not only are P3000 discs no longer needed, but a single bottle of G360Compound covers two process steps
PERMANENT G360 contains no �llers, so gives permanent results, avoiding costly reworks
Key Bene�ts
SUPER FASTCOMPOUND.
+44 (0) 1920 465 [email protected] www.farecla.comfareclaproductsltd
SURFACE FINISHINGSPECIALISTS
G360 Super Fast Compound used with a G MopSuper High Cut Pad easily glides over the surfaceand eliminates P1500 sanding marks rapidly and with little e�ort. This removes the need for P3000 abrasive discs, saving time and money. It is transparent in use, enabling the operator tosee scratch marks disappear permanently.
Using this compound with a G Mop Flexible YellowCompounding Foam eliminates all holograms and removes swirl marks leaving a great �nish onlighter colours.
For darker colours, the operator may wish to use G360 Super Fast Finish with a G Mop Flexible BlackFinishing Foam. This removes any �ne swirls andenhances the gloss level.
Product Description
Size1kg
CodeSFC101
Ctn Qty6
Product Information
P3000
Farécla Products Ltd | +44 (0) 1920 465 041 | [email protected] | www.farecla.com
LIT1
998
(V1
08-2
018)
+44 (0) 1920 465 [email protected] www.farecla.comfareclaproductsltd
SURFACE FINISHINGSPECIALISTS
CUT AT 1500RPM - SLIGHTANGLE - LIGHT PRESSURE
END AT 900RPM -USE FLAT - NO PRESSURE
NOT TOO ANGLED
COOLINGAIR FLOW
Remove P1500 sanding marks, permanently
Step 1: HIGH CUT
Only a smallamount needed
Cut at 1500rpm - light pressureEnd at 900rpm - no pressure
G Mop Super HighCut PadGMC650(6” / 150mm)
FLEXIBLE FOREASY HANDLING
Remove process marks - swirls and holograms, permanently
Step 2: MEDIUM CUT
900 - 1300rpmOnly a smallamount needed
Wipe cleanFC-3
G Mop Flexible Yellow Compounding FoamGMC624(6” / 150mm)
PRIME THE G MOP SUPER HIGH CUT PAD USING ONLY A SMALL AMOUNTOF PRODUCT.SPUR PADS FREQUENTLY TO AVOIDCLOGGING AND MAXIMISE PAD LIFE.G Mop Spurring Brush1090005
Tips
FOR BEST RESULTS ANDLONGER PAD LIFEG Mop Flexible Back Platefor 6” PadsGMB146 (14mm thread)GMB586 (5/8” thread)GMB166 (16mm thread)