Guide_1_HQ-Hab
12
BASE‐0 HQ UNIT Assembly Guide This is a step by step guide how to assemble the BASE‐0 HQ UNIT. You can follow the same basic steps to assemble the BASE‐0 HABITAT UNIT 1. Set contents: The individual parts are held in the frame by small uncut sections. You will need an X‐Acto knife to cut them free and also to cut away any excess material. For gluing it's best to use white wood glue. But before you glue anything, first dry‐fit the parts and make sure that everything is assembled correctly. These are the parts needed to assemble the ground floor: 1
description
guide de montage
Transcript of Guide_1_HQ-Hab
BASE‐0 HQ UNIT Assembly Guide
This is a step by step guide how to assemble the BASE‐0 HQ UNIT. You can follow the same basic steps to assemble the BASE‐0 HABITAT UNIT 1.
Set contents:
The individual parts are held in the frame by small uncut sections. You will need an X‐Acto knife to cut them free and also to cut away any excess material.For gluing it's best to use white wood glue. But before you glue anything, first dry‐fit the parts and make sure that everything is assembled correctly.
These are the parts needed to assemble the ground floor:
1
Start by putting together the base plate like this:
2
Next put together the walls as shown in the next two pictures.
3
Now push the walls all together into the base plate.
Add the side and top panels of the storage room.
4
Next you have to assemble the roof. It goes together just like the base plate.
The two little weird looking bits go in the hole on both short sides. They're meant to keep the roof from sliding sideways.
5
Your building should look like this:
Now on to the upper floor. These are the parts needed to assemble it:
6
Again start by putting together the base plate which goes together exactly like the roof before.
7
Now put together the 4 wall sections.
Next push the walls all together into the base plate.
Assemble the roof.
8
Your upper floor building should look like this:
These are the parts needed to assemble the doors, doorsteps and ramps:
9
The doors are pretty straight forward. Just put the doors into their stands.
Assemble the doorsteps and ramps as shown in the picture:
10
Finish the building by adding the railings. The finished set should look like this:
You may have noticed that I didn't push out any of the windows. It's entirely up to you if you want all your windows closed or open. Just take out those you'd like to have open.
Another thing you can do to improve how the roofs fit onto the buildings is cutting the legs of the railings as shown in the next picture. This is not necessary, but it will make the roof fall back into place easier during gaming.
11
12
