Post on 06-Sep-2015
501-19-1 501-19-1Bumpers
REMOVAL AND INSTALLATION
5. Disconnect the rear parking aid sensor electricalBumper Cover Rear, Explorerconnector, if equipped.
Removal and Installation6. CAUTION: To avoid damaging the
rear bumper cover, do not twist the cover1. Remove the taillamp assemblies.when removing.
2. Remove the 2 rear bumper cover bracket bolts. Remove the bumper cover.
To install, tighten to 6 Nm (53 lb-in). Lift the outer corners upward and pull thebumper cover straight up and out.
3. Remove the 9 bumper cover pin-type retainers.7. Transfer components as necessary.
4. Remove the 2 rear bumper bracket bolts.8. To install, reverse the removal procedure.
Copyright 2005, Ford Motor CompanyLast updated: 1/17/2006 2006 Explorer, Mountaineer, 10/2005