bumper-cover-8212-rear-explorer-removal-and-installation.pdf
1
501-19-1 501-19-1 Bumpers REMOVAL AND INSTALLATION 5. Disconnect the rear parking aid sensor electrical Bumper Cover — Rear, Explorer connector, if equipped. Removal and Installation 6. CAUTION: To avoid damaging the rear bumper cover, do not twist the cover 1. Remove the taillamp assemblies. when removing. 2. Remove the 2 rear bumper cover bracket bolts. Remove the bumper cover. • To install, tighten to 6 Nm (53 lb-in). • Lift the outer corners upward and pull the bumper cover straight up and out. 3. Remove the 9 bumper cover pin-type retainers. 7. Transfer components as necessary. 4. Remove the 2 rear bumper bracket bolts. 8. To install, reverse the removal procedure. Copyright 2005, Ford Motor Company Last updated: 1/17/2006 2006 Explorer, Mountaineer, 10/2005
-
Upload
michael-hernandez -
Category
Documents
-
view
15 -
download
1
Transcript of bumper-cover-8212-rear-explorer-removal-and-installation.pdf
-
501-19-1 501-19-1Bumpers
REMOVAL AND INSTALLATION
5. Disconnect the rear parking aid sensor electricalBumper Cover Rear, Explorerconnector, if equipped.
Removal and Installation6. CAUTION: To avoid damaging the
rear bumper cover, do not twist the cover1. Remove the taillamp assemblies.when removing.
2. Remove the 2 rear bumper cover bracket bolts. Remove the bumper cover.
To install, tighten to 6 Nm (53 lb-in). Lift the outer corners upward and pull thebumper cover straight up and out.
3. Remove the 9 bumper cover pin-type retainers.7. Transfer components as necessary.
4. Remove the 2 rear bumper bracket bolts.8. To install, reverse the removal procedure.
Copyright 2005, Ford Motor CompanyLast updated: 1/17/2006 2006 Explorer, Mountaineer, 10/2005
