7/25/2019 Operating Manual ptc
1/8 21
6.1. Preliminary checks
Check the tightness of the screws.
Check the oil level of the diesel engine.
Check the oil level of the power pack.
Check the battery is at the proper charge level.
Ensure that maintenance and periodic inspections have been carried out.
Check that the Emergency Stops are unlocked (console, pendant, Radio Control).
Read the engine notice carefully.
6.2. Starting diesel engine
ide the power pack. The white light "BATTERY" on
the dashboard lights.
2. Turn the ignition key to "1". The numerical display turns on. The "PREHEATING" indicator lights up
when the engine is cold.
3. Press the "START" button.
4. Release the "START" button as soon as the engine is running.
Contact
Control panel
7/25/2019 Operating Manual ptc
2/8 22
6.3. Operating procedure
With the Ecomode function during the cold start, the controls on the pendant are disabled untilthe engine has reached a temperature of 50C.
Opening clamp(s)
7/25/2019 Operating Manual ptc
3/8 23
Operation Action on the control box Consequences
Non Ecomode
Increase the speed of
the engine with "DIESEL
+ ".
" is of no use as the
Ecomode system adjust
by itself the diesel
engine speed. It must
remain in a central
position during the use
phase.
AUTO
speed.
Check that the charge pump pressure is higher than 12 bar at idle speed and 20 bar at maximum speed.
6.3.2. Closing the clamp
Action on the control box Consequences
Turn the switch to "Closing clamp", wait until
the green light comes on.
7/25/2019 Operating Manual ptc
4/8 24
Range Action on the control box Consequences
H/HF/HDTurn the switch to "Vibro
+".
starts vibrating.
Turn the switch to "Vibro
+".
HFV/HV
Rotate the "Amplitude"
switch towards "+".
7/25/2019 Operating Manual ptc
5/8 25
Range Action on the control box Consequences
H/HF/HD
Keep the switch on "Vibro
-" until the eccentrics stop
rotating.
stops vibrating.
Stop the amplitude by
turning the "Amplitude"
switch to the "-" position.
HFV/HV
Keep the selector switch
on "Vibro -" until the
eccentrics stop rotating.
6.3.5. Opening the clamp
Action on the control box Consequences
Turn the "Opening clamp" switch and
simultaneously press the "Open clamp" button.
A safety latch cancels this action during
vibration.
The green "Start" button on the dashboard lights up when the vibration is completely stopped.
7/25/2019 Operating Manual ptc
6/8 26
Operation Action on the control box Consequences
Non Ecomode
Slow down the engine by
turning the knob to
"DIESEL " and let it runfor several minutes.
AUTO
Never abruptly stop or slow down the diesel engine before the vibration stops completely. Such
an action may damage the equipment.
7/25/2019 Operating Manual ptc
7/8 27
6.4. Stop the power pack
l position.
2. Turn the ignition key to "0".
3. Turn the battery switch contact to "CUT". The "Battery" indicator light goes off.
7/25/2019 Operating Manual ptc
8/828
6.5. Radio Controlled Option
s the "Start" to turn on the Radio Control function.
Always check the status of the battery before using the Radio Control.
nd the battery status. If the green LED starts flashing,
the battery is discharged.
Procedure of the Radio Control:
Press "DIESEL +".
Press "Close clamp", the pressure in the clamps must reach 320 bar.
Press "VIBRO +" for 5 seconds to obtain the maximum flow rate.
Press "AMPLITUDE +" for 3 seconds minimum to maintain the vibration.
To reduce the vibration instantly, press "AMPLITUDE " for less than 3 seconds.
To completely stop the vibration, press "AMPLITUDE " for more than 3 seconds.
To stop the flow from the pumps, press "VIBRO " until the "START" indicator lights.
To decrease the speed of the diesel engine, press and maintain "DIESEL ".
To open the clamps, simultaneously press the two buttons "Open clamp."
Stop the Radio Control:
1. Stop the power pack.
2. Press Emergency Stop to turn off the Radio Control.
If the emergency stop button is pressed, if necessary, ensure that the electric jack of the pump is
in start position. Otherwise, bring it back by using the "VIBRO -" of the control box, before
restarting the power pack.
AMPLITUDE +
TURNING ON THE
RADIO CONTROL
VIBRO VIBRO +
STOP RADIO CONTROL
EMERGENCY STOP
BATTERY CHARGE INDICATOR
Top Related