You must use the frame geometry slide from your bike presentation. Decide if you want to design your...
-
Upload
kevin-anthony -
Category
Documents
-
view
214 -
download
0
Transcript of You must use the frame geometry slide from your bike presentation. Decide if you want to design your...
You must use the framegeometry slide from your bikepresentation.
Decide if you want to design your bike for a Small, Medium, Large, or Extra Large person. Your chart may be different.
1. Front Plane > New Sketch
2. Draw a horizontal construction line.This is the bottom line as shown in the Frame Geometry above.
3. Right-click on the line.Select the boat anchor to lock the line.
4. Sketch > LineDraw a path for the Seat Post (A)See the your chart for the angle and length.
5. New Plane - end of the line.Sketch a Profile Feature > Sweep Profile
Seat Tube
6. Sketch > LineDraw the Head Tube (E)See the your chart for the angle and length.
7. New Plane - end of the line.Sketch a Profile Feature > Sweep Profile
Head Tube
9. Sketch > LineDraw the Top Tube.
8. Front Plane > New Sketch
10. New Plane - end of the line.Sketch a Profile (Ellipse) Feature > Sweep Profile
Top Tube
12. Sketch > LineDraw the Down Tube.
11. Front Plane > New Sketch
13. New Plane - end of the line.Sketch a Profile (Ellipse) Feature > Sweep Profile
Down T
ube
15. Sketch > Circle.
14. Front Plane > New Sketch
16. Boss-Extrude > Mid Plane
Bracket Shell
17. Cut Extrude Seat Tube, Head Tube and Bracket Shell18. Fillet all intersections