Www.transtekinc.com. Second part is the oscillator itself. Hardware circuit that converts a DC...
-
Upload
lillian-lynne-marshall -
Category
Documents
-
view
216 -
download
2
Transcript of Www.transtekinc.com. Second part is the oscillator itself. Hardware circuit that converts a DC...
Current Oscillator/Demodulator
• Model of Focus: • Series 1000
Oscillator/Demodulator
• Design• Hardware oscillator circuit• Hardware demodulation circuit
www.transtekinc.com
Oscillator-Voltage Regulator• Three parts to oscillator: voltage regulator, oscillator, and
amplifier.• The voltage regulator takes input voltages of 11.5 to 30
VDC and holds it at a near constant value (about 12 V).• Output to voltage regulator will be used to power the
amplifiers through the circuit as being used as a voltage input.
• Second part is the oscillator itself.• Hardware circuit that converts a
DC signal to an AC signal. • Frequency of the oscillator is
determined by a RC combination, looking for a range of 1.5 to 12.5 kHz.
• Output voltage should be 1 VRMS.• Need to make an oscillator with
almost no harmonic distortion. http://www.electronics-tutorials.ws/oscillator/osc22.gif
Oscillator
Oscillator-Amplifier• Third subpart is the amplifier.• Will take the output signal of the Oscillator portion and
amplify the wave form.• Output voltage determined by a resistor, looking for 1 to 6
VRMS.
Oscillator Design Choices-DSP
• Advantage:• Reduction in parts needed
• No amplifier• No analog circuit components required
• Disadvantage:• Distortion in waveform due to sampling• Programing issues• Stability concerns