Work Package 2 / 3 TECHNOLOGICAL & PROCEDURAL HARMONISATION FixO3 General Assembly 14 th to the 16...
-
Upload
brett-hall -
Category
Documents
-
view
220 -
download
0
Transcript of Work Package 2 / 3 TECHNOLOGICAL & PROCEDURAL HARMONISATION FixO3 General Assembly 14 th to the 16...
![Page 1: Work Package 2 / 3 TECHNOLOGICAL & PROCEDURAL HARMONISATION FixO3 General Assembly 14 th to the 16 th October 2014, Heraklion-CRETE ESTOC, PLOCAN, andres.cianca@plocan.euandres.cianca@plocan.eu.](https://reader036.fdocuments.in/reader036/viewer/2022062321/56649e035503460f94aee48e/html5/thumbnails/1.jpg)
Work Package 2 / 3TECHNOLOGICAL & PROCEDURAL
HARMONISATION
FixO3 General Assembly 14th to the 16th October 2014, Heraklion-CRETE
ESTOC, PLOCAN, [email protected]@plocan.eu,
![Page 2: Work Package 2 / 3 TECHNOLOGICAL & PROCEDURAL HARMONISATION FixO3 General Assembly 14 th to the 16 th October 2014, Heraklion-CRETE ESTOC, PLOCAN, andres.cianca@plocan.euandres.cianca@plocan.eu.](https://reader036.fdocuments.in/reader036/viewer/2022062321/56649e035503460f94aee48e/html5/thumbnails/2.jpg)
WP 2 / WP3 – Technological & Procedural HarmonisationTask 2.1:Review of the current status of all fixed observing sitesTask 3.1: Assessment of procedures
Current status of the Observatory (October 2014)
• Position: 29,181º N; 15.585º W• ODAS Buoy + Mooring line• Sensors at ODAS buoy:Meteo.: Barometric Pressure, air temperature,
Relative humidity, PAR and Wind speed and direction.
Ocean: sea surface temperature, salinity, dissolved oxygen, pH, pCO2, Chlorophyll, turbidity.
• Sensors at mooring line (100m depth): Temperature, salinity, dissolved oxygen, chlorophyll and current
• people involved: Xabier Remirez, A. Cianca and other technicians
![Page 3: Work Package 2 / 3 TECHNOLOGICAL & PROCEDURAL HARMONISATION FixO3 General Assembly 14 th to the 16 th October 2014, Heraklion-CRETE ESTOC, PLOCAN, andres.cianca@plocan.euandres.cianca@plocan.eu.](https://reader036.fdocuments.in/reader036/viewer/2022062321/56649e035503460f94aee48e/html5/thumbnails/3.jpg)
Significant results/highlights
Data Management and Data Access
WP 2 / WP3 – Technological & Procedural HarmonisationTask 2.1:Review of the current status of all fixed observing sitesTask 3.1: Assessment of procedures
Real Time (parameters) Delayed Mode(Parameters at 100m)- Temperature- Salinity- Dissolved Oxygen- Current- Chlorophyll
![Page 4: Work Package 2 / 3 TECHNOLOGICAL & PROCEDURAL HARMONISATION FixO3 General Assembly 14 th to the 16 th October 2014, Heraklion-CRETE ESTOC, PLOCAN, andres.cianca@plocan.euandres.cianca@plocan.eu.](https://reader036.fdocuments.in/reader036/viewer/2022062321/56649e035503460f94aee48e/html5/thumbnails/4.jpg)
WP 2 / WP3 – Technological & Procedural HarmonisationTask 2.1:Review of the current status of all fixed observing sitesTask 3.1: Assessment of procedures
Operating Scheme/Schematic (with time intervals)Pre- Deployment (5 months)- Maintenance buoy and sensors (cleaning and repairs)-Calibration for sensors (if needed)-Sensor and mooring line purchase (if needed).-Sensor validation prior to fix in the buoy (water tank and laboratory measurements)- On land test prior coastal-site deployment
Coastal-site Deployment15- 30 days)-after deployment, the buoy is recovered, buoy and sensors are cleaned for ESTOC deployment- Sensor maintenance or replacement (if needed)
ESTOC-site Deployment2 - 5 days
(ship-time availability and weather conditions)
On the Field (1 day)Casual visit because of communication problems. For that, it is necessary very good weather and ship availability.Pre- Deployment: sensor validations – land test – coastal-site test
- Design issue: a bad weight distribution produced a slight tilting angle. Redistribution of weight.-Over expected power consumption from pCO2 and pH sensor. Change in the configuration of the sensors.- Difficulties with meteorological sensor validation (calibration from manufacturers). Only a comparison with sensors from AEMET was available.
![Page 5: Work Package 2 / 3 TECHNOLOGICAL & PROCEDURAL HARMONISATION FixO3 General Assembly 14 th to the 16 th October 2014, Heraklion-CRETE ESTOC, PLOCAN, andres.cianca@plocan.euandres.cianca@plocan.eu.](https://reader036.fdocuments.in/reader036/viewer/2022062321/56649e035503460f94aee48e/html5/thumbnails/5.jpg)
WP 2 / WP3 – Technological & Procedural HarmonisationTask 2.1:Review of the current status of all fixed observing sitesTask 3.1: Assessment of procedures
ESTOC seasonal samplingCalibration CTD/sampler profiler
Mooring Deployment
Deployment procedure:
Accessory buoy deployment
Mooring line Deployment and fixing sensors on the
line or frame
Anchor launching
Accessory buoy recovering and replacement for the
ODAS buoy
R/V Sarmiento de Gamboa
![Page 6: Work Package 2 / 3 TECHNOLOGICAL & PROCEDURAL HARMONISATION FixO3 General Assembly 14 th to the 16 th October 2014, Heraklion-CRETE ESTOC, PLOCAN, andres.cianca@plocan.euandres.cianca@plocan.eu.](https://reader036.fdocuments.in/reader036/viewer/2022062321/56649e035503460f94aee48e/html5/thumbnails/6.jpg)
On the field:
WP 3 – Procedural HarmonisationTask 3.1: Assessment of procedures
RAW DATA
RelationalDatabase(postGIS)
METADATA
ARGOS ; Data transfer and position alarms
ThreddsData Server
(TDS)
RTQCapplied
Data files
Django web
framework
PLOTS
USER
NetCDF
Oceansite
s