Wired/Wireless LAN Option
Transcript of Wired/Wireless LAN Option
Wired/Wireless LAN Option
92-2587-01 Rev.B
3
Overview This document describes the installation and use of the Wired/Wireless LAN option for the I-
Class Mark II printer. Follow the steps to begin installing the option.
CAUTION
For safety and to avoid equipment damage, turn OFF the power switch and
unplug the AC power cord from the printer before starting this installation.
Contents This kit contains the following items:
LAN Card Assembly Wireless Board Assembly Antenna Connector (wireless kits only) Antenna (wireless kits only) Standoff, 6mm Hex (2 for LAN card, 2
for wireless board) Locking Nut, 5.5mm (2 for LAN card, 2
for wireless board) Screw, Phillips, M4X6 (2)
Tools Required To install this option, you will need:
Phillips screwdriver 5mm Hex Driver 5.5mm Hex Driver 6mm Hex Driver 5/16” or 8mm Wrench Screws, Phillips M4 (2)
4
Installing the Option Install the LAN Card as described below:
A) Turn off and disconnect the power cord from the printer. Remove the three Screws
from the left side cover of the printer.
B) Open the printer’s cover, loosen (do not remove) the two Screws on the inside of the
printer and lift the Cover Assembly up and off the printer.
Screws
CoverAssembly
Screws
5
C) Remove the 5mm Screw and Cover
Plate from the rear of the printer.
Cover Plate
5mm Screw
D) Install the two 6mm Standoffs into the main board in the locations shown.
6mmStandoffs
6
E) Install the LAN Card into the printer. First insert the “Port” end into the cut-out in the
rear of the printer. Then pivot the LAN Card onto the two Standoffs.
F) Install the two 5.5mm Nuts.
5.5mmNuts
G) LAN Card installation is complete. If your kit contains the Wireless Option, Proceed to
“Installing Wireless Module and Antenna” on the next page. Otherwise re-install the
printer’s cover and refer to the Operator’s Manual for connection and configuration
information.
7
Installing Wireless Module and Antenna Install the Wireless Module and Antenna as described below:
A) Install the two 6mm standoffs into the main board in the locations shown.
B) Install the wifi board into the printer. First insert the “port” end into the cut-out in the
rear of the printer. Then pivot the wifi board onto the two standoffs.
8
C) Install the two 5.5mm nuts.
D) Remove the nut and washer from the antenna connector.
NutAntenna
ConnectorWasher
E) Insert the Antenna Connector through the hole in the printer’s Back Panel.
F) Re-install the Nut and Washer onto the Antenna Connector and tighten using a 5/16”
or 8mm Wrench.
G) Connect the Antenna Connector Wire to the connector on the Wireless Module.
9
H) Screw the Antenna onto the Antenna Connector and pivot the Antenna up for best
reception.
Antenna Antenna
I) Wireless installation is complete. Re-install the printer’s cover and refer to the
Operator’s Manual for connection and configuration information.