What I Used With Optional Substitutes
description
Transcript of What I Used With Optional Substitutes
![Page 2: What I Used With Optional Substitutes](https://reader036.fdocuments.in/reader036/viewer/2022083010/563dbb7c550346aa9aad91d6/html5/thumbnails/2.jpg)
What I used with optional substitutes:Parts:
1 10 foot 3/4 inch conduit ~1 foot of 3/4 inch schedule 40 pvc ~1 foot of 1 inch schedule 40 pvc 4 LASCO 3/4-in x 1/2-in Dia 90-Degree PVC Sch 40 Side Outlet Elbow 4 LASCO 1/2-in Dia x 3/4-in Dia PVC Sch 40 Adapter 1 5/16 inch 6 foot threaded rod 4 5/16 inch bearings (optional) 2 3 inch aluminum beams
clothespin ~1 foot of Kiln-Dried Poplar Board (Common: 1-in x 6-in x 24-in;
Actual: 0.75-in x 5.5-in x 24-in) any type of wood will wook
1 Camera mount 1/4 inch 20 thread size bolt
1 K'NEX motor
![Page 3: What I Used With Optional Substitutes](https://reader036.fdocuments.in/reader036/viewer/2022083010/563dbb7c550346aa9aad91d6/html5/thumbnails/3.jpg)
any motor 1 Medium K'NEX gear
any gear to fit the threaded rod 1 Small K'NEX gear
any gear to fit your motor 4 Hose clamps Paint Motor controller Wire Normally on contact switch Small hinge Wood screws #6 32 thread machine screws of varying lengths Rubber bands Lubricating oil
The cost of the required parts was about $100. I had many of the parts, as you might also, so your cost could be lower.