Wesco fadal reman slideshow 2016
-
Upload
lisa-emanuel -
Category
Devices & Hardware
-
view
162 -
download
1
Transcript of Wesco fadal reman slideshow 2016
“At West Coast CNC, We measure our success…by your success”.
38,000 Square Foot Manufacturing Facility Located in Chatsworth, CA.
Typical Used Fadal 4020 Arriving
It starts with a freshly painted casting and NEW Turcite on X/Y/Z
Re-Plumb all way lube lines
Complete Rebuilding of motor and adding the Posi-
Belt System
Each Spindle is rebuilt
using new spindle
bearings
New Spindle drive for each Reman
Machine
A 20 Hour burn in or test period is completed on AMPS, Motors, Axis Cards, and Inverters
before being installed on a machine
Re-cut Table to ensure squareness
After the table is cut a 20 hour cycle
takes place testing X/Y/Z, spindle RPM,
and tool changes
Each Machine is Ballbar/Laser Calibrated and New or Rebuilt Ballscrews and New thrust bearings are installed for each axis
Fadal 4020 VMC Completely Remanufactured
Fadal VMC 6030 Completely Remanufactured
West Coast CNC Parts Warehouse – 10,000 Sq Ft.
West Coast CNC Service (1 of 3)