TraceTek Flashers

21
TraceTek Flashers

description

TraceTek Flashers. Two simple units for visual leak detection. In some applications it makes sense to eliminate wiring and expensive control room equipment and rely on people. Two different models of visual leak indicators are presented for market evaluation - PowerPoint PPT Presentation

Transcript of TraceTek Flashers

Page 1: TraceTek Flashers

TraceTek Flashers

Page 2: TraceTek Flashers

2

Two simple units for visual leak detection

• In some applications it makes sense to eliminate wiring and expensive control room equipment and rely on people.

• Two different models of visual leak indicators are presented for market evaluation

• Model 1 is powered by 2 “AA” size batteries

• Mode 2 is solar powered.

• Both devices are adapted to work with any TraceTek sensor cable or probe and can also be used with other “dry contact” type detectors

Page 3: TraceTek Flashers

3

Model 1: Battery Powered

• This unit uses 3 high efficiency LED’s that can be easily seen from in-front of the unit

• Visibility is great in the dark and OK in day light• When the sensor cable is contacted by the

appropriate liquid, the LED’s will begin to flash• Flashing will continue for at least 30 days• However, if no one notices the flashing light,

the Flasher will eventually deplete the batteries and there will be no indication at all.

• The batteries need to be replaced once a year• If the batteries run low the unit will show a

“double flash” pattern for at least 1 month, but eventually, if the batteries go dead, the unit will not flash at all including in leak situations

• Each unit comes equipped with a “TEST” key that can be turned on to verify both good batteries and a that an undamaged sensor cable is connected.

Page 4: TraceTek Flashers

4

Model 2: Solar Powered

• This unit has a solar panel to charge a storage battery inside the unit

• There are 18 high intensity LEDs within the lens that provide 360 degree visibility

• The LEDs are bright enough to be seen even in daylight conditions from any direction.

• The storage batteries have the capacity to keep the LED’s flashing for at least 48 hours after a leak is detected (even if there is no sunlight). And sunlight can keep the flasher going longer as some charge is recovered.

• If the storage battery runs low, the circuit automatically stops the flashing long enough to recharge the batteries to an acceptable level then the flashing starts again.

• The life time of these units is projected to be 5 to 8 years after which the storage batteries loose their capacity to hold the solar charge.

Page 5: TraceTek Flashers

5

The selection of cable type determineshow the Flasher will operate.

TT5000 for fuels like jet, diesel or gasoline TT3000 for water, waste streams, and any other conductive liquid

TT5001 for organic solvents like acetone, MEK, Toluene or NMP

TT7000 for sulfuric or nitric acid(currently in Beta Testing)

Page 6: TraceTek Flashers

6

Other probes or contact devices work too

FFS Probes for fast fuel sensing in a sump or pit

(currently in Beta Test)

Mini-Probes for quick detection of water or

conductive liquids in a confined space

Any float switch or normally open contact that closes to indicate an alarm

condition

Page 7: TraceTek Flashers

7

Applications

• Large Above Ground Storage Tanks – Monitoring beneath tank floors with sensor placed in slotted conduit beneath the

tank– Monitoring the interstitial space beneath primary tank floor plate for tanks that have

been retrofitted with a double bottom

• Containment monitoring for small above ground storage tanks

• Monitoring beneath buried pipeline and tank valves with sensor cable placed in slotted conduit and buried in the soil

• Monitoring vertical sampling wells in valve manifold areas

• Temporary monitoring of drip pans placed under areas where flanges and valves have undergone recent maintenance

• Sump and pit monitoring in chemical storage areas

• High level indicator for sumps and containments with normally closed drainage

Page 8: TraceTek Flashers

8

AST Tank Floor monitoring

Page 9: TraceTek Flashers

9

AST Tank Floor monitoring

Page 10: TraceTek Flashers
Page 11: TraceTek Flashers
Page 12: TraceTek Flashers

12

Buried Valve Monitoring

Page 13: TraceTek Flashers

13

Buried Valve Monitoring

Page 14: TraceTek Flashers

14

Buried Valve Monitoring

Page 15: TraceTek Flashers

15

TT5000 in Slotted PVC Conduit

Page 16: TraceTek Flashers

16

Vertical Monitoring Well Monitor

Page 17: TraceTek Flashers
Page 18: TraceTek Flashers

18

Sump Monitor

Page 19: TraceTek Flashers
Page 20: TraceTek Flashers

20

Small Above Ground Tanks in Vaults

Page 21: TraceTek Flashers

21

Why you might consider a Flasher

Less expensive than mains powered equipment with remote telemetry

Low cost to install and commission

Simple maintenance – easy to test

No system integration requirements

Easy to retrofit

Typically fits into the maintenance budget rather than the capital equipment budget

Can be installed in Hazardous Areas(Approvals for C1D1, Zone 1 are pending)

Relies on visual recognition and response -- People Dependent

Batteries need to be replaced annually (battery units only)

Solar unit has a finite product life due to aging of storage batteries

If the unit is completely ignored and never tested, a leak could go undetected

Reasons For: Reasons Against: