This guide may change without notice. See ...Orange/Black In A7 Dk.Blue In A8 Red/Blue In A9...
Transcript of This guide may change without notice. See ...Orange/Black In A7 Dk.Blue In A8 Red/Blue In A9...
This guide may change without notice. See www.fortin.ca for latest version.Ce guide peut faire l’objet de changement sans préavis. Voir www.fortin.ca pour la récente version.
DESCRIPTION | DESCRIPTION
Gateway module, located at dash board driver's side, Module Passerelle réseau, situé au tableau de bord côté conducteur.
()Parking Lights()Parking Lights
Parking Lights switchCommutateur des feux de stationnement
Under the hoodSous le capot
(-)Parking Lights
()Parking Lights
If not equiped with hood pin.si le véhicule n'est pas équipé d'un contact de capot
Page 3 / 7
This guide may change without notice. See www.fortin.ca for latest version.Ce guide peut faire l’objet de changement sans préavis. Voir www.fortin.ca pour la récente version.
Yellow In A1Purple In A2
Purple/White In A3Green Out A4White Out A5
Orange In A6Orange/Black In A7
Dk.Blue In A8Red/Blue In A9
Lt.Blue/Black A10Black Out A11
Pink Out A12Yellow/Black In A13Brown/White Out A14
Pink/Black Out A15Purple/Yellow A16
Green/White A17Green/Red A18
White/Black A19Lt.Blue A20
C5 BrownC4 Gray/Black C3 GrayC2 Orange/BrownC1 Orange/Green
D6 White/RedD5 White/BlueD4 White/GreenD3 Yellow/RedD2 Yellow/BlueD1 Yellow/Green
A C
D
AUTOMATIC TRANSMISSION WIRING CONNECTION | SCHÉMA DE BRANCHEMENT TRANSMISSION AUTOMATIQUE
(-) Unlock(-) Lock
(-) Lock/Unlock input external control | Contrôle du (-) verrouillage devérrouillage entrée externe
Start / Stop external controlContrôle de démarrage/arrêt externe
Start/Stop external
Hood pin
Hood pin only required on vehicles not equipped with a factory hood pin.Commutateur de capot requis seulement si le véhicule n'est pas équipé de cette composante.
SAFETY OVERRIDE SWITCHCOMMUTATEUR DE SÉCURITÉ
Guide # 68991
2 3 4 5 6 7 8
9 10 11 12 141516
1
13
()PARKING LIGHTS
Parking Lights switchBack view, 14-pin black
connector.
Commutateur des feux de stationnement. Vue de dos,
connector Noir 14-pins.
(-)PARKING LIGHTS
CUT
D3
D1
MALE T-HARNESS PLUGCONNECTEUR
DU T-HARNAISMÂLE
FEMALE T-HARNESS PLUGCONNECTEUR FEMELLE DU T-HARNAIS
MALE VEHICLE PLUGCONNECTEUR MÂLEDU VÉHICULE
At hood latch
Au commutateur
de capot
Black/PurpleNoir/Mauve
GreyGris
Gateway module, Behind OBD-II connector - located at dash board driver's side - Back
view, 24-pin black connector.
Module Passerelle réseau, derrière le connecteur OBD-II situé dans le tableau de
bord, côté conducteur. Vue de dos,connector Noir de 24-pin.
Black/PurpleNoir/Mauve
GreyGris
F-SERIES
MKC
Make a jumper if not equiped with hood
pin.Court-circuiter les 2
fils si le véhicule n'est pas équipé d'un
contact de capot1 2
A18
OPTIONALFACULTATIF
(-)PARKING LIGHTS
(-)PARKING LIGHTS
(-)PARKING LIGHTS
(+)Ignition Out
B
OPTIONALOPTIONNEL
OPTIONAL RFKITKIT RF OPTIONNEL
RF KITKIT RF
WITH | AVEC DATA-LINK:Direct connectionBranchement directe
REMOTESTARTER
DÉMARREURÀ DISTANCE
CABLE MUST BE INCLUDED WITH THE RF KIT. CÂBLE DOIT ÊTRE INCLUS AVEC LE KIT RF.
BLUE FEMALE CONNNECTOR CONNECTEUR FEMELLE BLEU
OROU
RS3 IN/OUT (+)Ignition Can be required Peux être requis
A16
Page 4 / 7
PUSH-TO-START VEHICULEVÉHICULE BOUTON POUSSOIR
REGULAR KEY VEHICLEVÉHICULE CLÉ RÉGULIÈRE
4
LOCK
ACC ON
PUSH
START
IGN
TURNON/RUN
Turn the Ignition to the ON/RUN position.
Tournez la clé en position ignition (ON).
The BLUE LED will flash rapidly 10x times. Key bypass programmed.
La DEL BLEUE clignotera rapidement: Réseau CAN programmé.
5PUSH-TO-START VEHICULE
VÉHICULE BOUTON POUSSOIRREGULAR KEY VEHICLE
VÉHICULE CLÉ RÉGULIÈRE
The BLUE LED will turn off. La DEL BLEUE s'éteint.
The module is now programmed. Le module est
programmé.Use the remote of the remote starter or security system to test all of the supported features to ensure proper programming.
Testez toutes les fonctions supportées sur le véhicule avec la télécommande du démarreur à distance ou du système de sécurité.
Press and release the Push-to-Start button once to turn off the ignition.
Appuyez et relâchez 1 fois sur le bouton démarrage (Push-to-Start) pour éteindre l'ignition.
Turn the Ignition to the OFF position.
Tournez la clé à OFF.
LOCK
ACC ON
PUSH
START
OFFTURNOFFOFF
x1PRESS
1
2
3
ONx1PRESS
Press and release the Push-to-Start button to turn ON the ignition.
Appuyez et relâchez le bouton démarrage (Push-to-Start) pour allumer l'ignition.
Insert the required remaining connectors.
Insérez les connecteurs requis restants.
Release the programming button when the LED is BLUE.
Relâchez le bouton de programmation quand la DEL est BLEUE.
x1HOLD
Press and hold
Insert
theprogramming button:
the 4-Pin (Data-Link)connector.
Appuyez maintenirenfoncé
Insérez
etle bouton de
programmation:le connecteur 4 pins
(Data-Link) The Blue, Red, Yellow andBlue & Red LEDs willalternatively illuminate.
Les DELs Bleue, Rouge,Jaune et Bleue & Rouges'allumeront alternativement.
LED may differ depending on the module casing.L’apparence des DELS peut différer selon le boîtier du module.
RELEASE
If the LED is not solid BLUE disconnect the 4-Pin connector (Data-Link) and go back to step 1.
ON BLUE BLEU Si le DEL n'est pas BLEU
débranchez le connecteur 4 pins (Data-Link) et allez au début de l'étape 1.
IGNITION ON FLASH X10
IGNITION ON IGNITION OFF
OFF
This guide may change without notice. See www.fortin.ca for latest version.Ce guide peut faire l’objet de changement sans préavis. Voir www.fortin.ca pour la récente version.
PROGRAMMING PROCEDURE | PROCÉDURE DE PROGRAMMATIONPage 5 / 7
This guide may change without notice. See www.fortin.ca for latest version.Ce guide peut faire l’objet de changement sans préavis. Voir www.fortin.ca pour la récente version.
REMOTE STARTER FUNCTIONALITY | FONCTIONNALITÉS DU DÉMARREUR À DISTANCE
Remote start the vehicle.
Démarrez à distance.
All doors must be closed.
Toutes les portes doivent être fermées
UNLOCK
The vehicle can now be put in to gear and
driven.
Vous êtes maintenant prêt à embrayer et prendre la route.
PUSH-TO-START VEHICULE | VÉHICULE BOUTON POUSSOIR
ONx1PRESS
DO NOT PRESS THE BRAKE PEDAL
Press and release the Push-to-Start buttononce to
turn ON the ignition.
NE PAS APPUYER LA PÉDALE DE FREIN
Appuyez et relâchez une fois le bouton démar-
rage (Push-to-Start) pour allumer l'ignition.
Remote start the vehicle.
Démarrez à distance.
All doors must be closed.
Toutes les portes doivent être fermées
UNLOCK
The vehicle can now be put in to gear and
driven.
Vous êtes maintenant prêt à embrayer et prendre la route.
REGULAR KEY VEHICLE | VÉHICULE CLÉ RÉGULIÈRE
LOCK
ACC ON
PUSH
START
IGN
TURNON/RUN
Turn the Ignition to the ON/RUN position.
Tournez la clé en position ignition (ON).
START
START
Unlock the doors with either: the OEM remote or the remote-starter remote or the proximity remote.
Déverrouillez les portes avec soit: la télécommande d'origineou la télécomande du démarreur à distance ou la télécommande de proximité
Unlock the doors with either: the OEM remote or the remote-starter remote.
Déverrouillez les portes avec soit: la télécommande d'origineou la télécomande du démarreur à distance.
Enter the vehicle with the
SMART-KEY.
Entrez dans le véhicule avec la
clé intelligente (SMART-Key)
sur vous
Page 6 / 7
ALL
Service No : 000 102 04 2536
Date: xx-xx
INTERFACE MODULE
Made in CanadaPATENTS PENDING US: 2007-228827-A1
www.fortinbypass.com
HARDWARE VERSION FIRMWARE VERSION
Module label | Étiquette sur le module
Notice: Updated Firmware and Installation GuidesUpdated fi rmware and installation guides are posted on our web site on a regular basis. We recommend that you update this module to the latest fi rmware and download the latest installation guide(s) prior to the installation of this product.
Notice: Mise à jour microprogramme et Guides d’installationsDes mises à jour du Firmware (microprogramme) et des guides d’installation sont mis en ligne régulièrement. Vérifi ez que vous avez bien la dernière version logiciel et le dernier guide d’installation avant l’installation de ce produit.
WARNINGThe information on this sheet is provided on an (as is) basis with no representation or warranty of accuracy whatsoever. It is the sole responsibility of the installer to check and verify any circuit before connecting to it. Only a computer safe logic probe or digital multimeter should be used. FORTIN ELECTRONIC SYSTEMS assumes absolutely no liability or responsibility whatsoever pertaining to the accuracy or currency of the information supplied. The installation in every case is the sole responsibility of the installer performing the work and FORTIN ELECTRONIC SYSTEMS assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly or any other way. Neither the manufacturer or distributor of this module is responsible of damages of any kind indirectly or directly caused by this module, except for the replacement of this module in case of manufacturing defects. This module must be installed by qualifi ed technician. The information supplied is a guide only. This instruction guide may change without notice. Visit www.fortinbypass.com to get the latest version.
MISE EN GARDE L’information de ce guide est fournie sur la base de représentation (telle quelle) sans aucune garantie de précision et d’exactitude. Il est de la seule responsabilité de l’installateur de vérifi er tous les fi ls et circuits avant d’effectuer les connexions. Seuls une sonde logique ou un multimètre digital doivent être utilisés. FORTIN SYSTÈMES ÉLECTRONIQUES n’assume aucune responsabilité de l’exactitude de l’information fournie. L’installation (dans chaque cas) est la responsabilité de l’installateur effectuant le travail. FORTIN SYSTÈMES ÉLECTRONIQUES n’assume aucune responsabilité suite à l’installation, que celle-ci soit bonne, mauvaise ou de n’importe autre type. Ni le manufacturier, ni le distributeur ne se considèrent responsables des dommages causés ou ayant pu être causés, indirectement ou directement, par ce module, excepté le remplacement de ce module en cas de défectuosité de fabrication. Ce module doit être installé par un technicien qualifi é. L’information fournie dans ce guide est une suggestion. Ce guide d’instruction peut faire l’objet de changement sans préavis. Consultez le www.fortinbypass.com pour voir la plus récente version.
Copyright © 2006-2014, FORTIN AUTO RADIO INC ALL RIGHTS RESERVED PATENT PENDING
TECH SUPPORTTél: 514-255-HELP (4357) 1-877-336-7797
ADDENDUM GUIDEWEB UPDATE | MISE À JOUR INTERNET
www.fortinbypass.com
EVO-ALL
Page 7 / 7