Tagger and Vacuum Chamber Assembly Procedure. Preassembly of second bottom yokes and poleshoes. a)...
-
date post
20-Dec-2015 -
Category
Documents
-
view
216 -
download
0
Transcript of Tagger and Vacuum Chamber Assembly Procedure. Preassembly of second bottom yokes and poleshoes. a)...
Preassembly of second bottom yokes and poleshoes. a) Install special support. b) Place the second bottom yokes on special support. c) Place the bottom poleshoes on the second bottom yokes and connect with bolts.
• Magnetic field measurement without vacuum.
• Full vacuum test.
Preassembly of first bottom yoke and second bottom yoke with poleshoe. a) Remove the second bottom yoke with poleshoe from special support and install first bottom yoke. b) Place the second bottom yoke with bottom poleshoe on the first bottom yoke and connect them with bolts.
Place the bottom yokes and poleshoes on the support frame and adjust them to correct height and orientation.
Attach position vacuum chamber with O-ring around the bottom poleshoes and tighten O-ring with compression bolts.
Position first top yoke and connect it to the second back yoke and top poleshoes with bolts and side clamps.