SIGMACOVER™ 350

SIGMACOVER™ 350 Medium to Heavy Duty Floor paint

• Self priming tintable high solids epoxy coating

• Available in range of colours

• Resistance to splash and spillage of a wide range of chemicals

• Abrasion resistant coating

• Quick drying

Recommended for industrial flooring in factories, warehouses, garages and stable. Resists wet conditions and splash & spillage of dirt, oils, acids, alkalines, solvents and salt solutions.

Can be applied by brush, roller and spray

Primer/sealer SIGMACOVER 350 epoxy coating

Thin down till 10% met thinner 91-92

Spreading rate 6.2 sqm/l*

Dft: 125 µm

Finish SIGMACOVER 350 epoxy coating

Spreading rate 5.7 sqm/l*

Dft: 125 µm

Appereance Semi gloss

Colours Various colours

Averange dft 125 microns (0.125 mm) per coat

Recoatable 6 hrs at 20ºC

Volume solids 72%

Please check PDS, application instructions and information

sheets for additional information in relation tot his product.

PPG Protective & Marine Coatings P.O. Box 58034, 1040 HA Amsterdam, The Netherlands.Tel +31 (0)20 407 5050 Fax +31 (0)20 407 5059 Email PMC@ppg.com Website www.ppgpmc.comNo rights can be derived from the content of this publication. Unless otherwise agreed upon in writing, all products and technical advice given are subject to our standard conditions of sale, available on our website www.ppgpmc.com. All rights reserved. Bringing innovation to the surface is a registered trademark of PPG Industries Ohio, Inc.

Instructions for applying SIGMACOVER 350 medium to heavy duty floor paint

Minimum application conditions

Minimum air and surface temperature for coating is 5°C.Ensure that substrates are cured and dry with maximum moisture content of 4%. To avoid intercoat adhesion problems and lossof gloss during the drying period keep temperature 3°C above the dew point during the application of the system.

Cleanliness of the floor

Concrete with a trowelled surface will give the best overall appearance. Surface should be clean and dry. Light abrasive blasting or grinding is recommended to remove all chalk, surface glaze and laitance on bare concrete. Remove all surface dust and debris by vacuum cleaning. Where there are existing coatingscompatibility and soundness should be checked prior to coating to determine best course of preparation/application.

Application equipment

SIGMACOVER 350 should be thoroughly mixed using a power mixer. Uniform coverage of SIGMACOVER 350 is best achieved by pour & roll application. Small areas can be applied by brush.

Application instructions

Mix the resin and cure components of SIGMACOVER 350 with a power mixer adding 10% by volume of Thinner 91-92 (uncoated concrete only) to assist penetration. Pour and roll onto the floor surface to obtain an average coverage of 6 m2 per litre. Once the 1st coat of SIGMACOVER 350 has cured for 6 hours at 20°C, mix the resin and cure of the 2nd coat of SIGMACOVER 350, without thinning, then pour and roll onto the floor surface, to finish the paint system, at an average coverage of 5.5 m2 per litre.

Coverage rate

Primer coat 6 sqm/l*.Finish coat 5.5 sqm.l litre*.

* Coverage rates typical for this system. Uneven surfaces will consume more material.

Drying times before useAllow the complete system to dry for 24 hours at 20°Cbefore light traffic exposure.

SIGMACOVER™ 350 Medium to Heavy Duty Floor paint