Setco Spinlde Service of Avtec Company's product
31
Dismentling process
-
Upload
vittal-kulkarni -
Category
Services
-
view
62 -
download
2
Transcript of Setco Spinlde Service of Avtec Company's product
Bearing stabilization test : In this process spindle runs at maximum speed , so that bearing should adjust and set according to spindle conditon . In this process temperature should not exceed +10 degree Celsius of room temperature. If temperature raised , then again repeat the procedure for a duration of 30 minutes to 1 hour.
Aac
Assembly process: Material expends , when temperature raise up to 80- 100 degree Celsius . So that easily assemble on to spindle shaft
Clamping force test is done during after completion of repairing process. To check quality parameters of after service.