Samsung LN-T5265F T-Con Board ReplacementWritten By: Steven Carlton

Samsung LN-T5265F T-Con Board Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 6

TOOLS:Phillips #1 Screwdriver (1)

Samsung LN-T5265F T-Con Board Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 6

Step 1 — Stand

Lay the TV screen-side down on aflat, soft surface.

Remove four Phillips screwsattaching the stand to the TV.

Step 2

Slide the stand out from the bottom of the TV.

Samsung LN-T5265F T-Con Board Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 6

Step 3 — Rear Case

Remove fifteen Phillips screws securing the rear case to the front.

If present, remove four Phillips screws for the VESA mount.

Carefully lift the rear case upwards to separate it from the frame of the TV.

Samsung LN-T5265F T-Con Board Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 6

Step 4 — T-Con Board

The Timing Controller (T-Con) board is located at the top center behind a metal shield.

Remove four Phillips screws.

Tilt the metal shield towards the top of the TV and lift away.

Step 5

Disconnect the two ribbon cables atthe top by flipping up the retainingflaps and sliding the ribbons straightup towards the top of the TV.

Samsung LN-T5265F T-Con Board Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 6

To reassemble your device, follow these instructions in reverse order.

This document was last generated on 2017-06-20 12:54:29 PM.

Step 6

Disconnect the bottom ribbon cableby depressing the two buttons oneither side of the connector andsliding down towards the bottom ofthe TV.

Samsung LN-T5265F T-Con Board Replacement

© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 6