Sample Assignment For Mini Projec in Mechatronics
Transcript of Sample Assignment For Mini Projec in Mechatronics
-
8/18/2019 Sample Assignment For Mini Projec in Mechatronics
1/1
Uva Wellassa University SCT 372 – 1 Mini Project
Department of Science & Technology Mechatronics Specialization
Uva Wellassa UniversityDepartment of Science & Technology
(Mechatronics Specialization Area)
SCT 372 –
1 Mini Project
ASSIGNMENT 1: 1ST PROGRESS
ASSIGNED : 16.11.2015 / DUE: 23.11.2015
Each Student has to prepare a PowerPoint presentation together with a progress report to
illustrate the project progress. Progress of the project will be measured based on the duration.
You should be able to provide sufficient progress by the presentation due date.
1. Presentation
Your presentation has to have a minimum of 15 slides except the
introduction and the reference slides. Time allocation for the
presentation would be 10min. Entire allocated time should be used in
the presentation.
2. Report
Report should provide, details in full what presented in the presentation.
The progress report should essentially include an introduction, literature
review and a method statement.
Report should include Description on the project and project
components.
Notes:
- Keep a Margin of 3.2cm (1.25 inches) on the left side and 2.5cm (1 inch) on all other sides.
Maintain a uniform margin on the right hand side of the paper.
- Reports and papers must be free of erasures and manual corrections.
- Point 12, Font Times New Roman
-