Recessed Light Can Cover Installation Details
-
Upload
battic-door-energy-conservation-products -
Category
Self Improvement
-
view
521 -
download
3
Transcript of Recessed Light Can Cover Installation Details
Battic Door Energy Conservation ‐ www.batticdoor.com ‐ 508 320 9082 ‐ [email protected]
Step 1
Ensure the light is firmly fastened to the ceiling joist and all insulation is
cleared to facilitate a air tight seal once foam is installed around the base of the seal a light.
Battic Door Energy Conservation ‐ www.batticdoor.com ‐ 508 320 9082 ‐ [email protected]
Step 2
Confirm the fixture has at least a 1/2" of clearance on all sides when positioned on the rails of the fixture.
Step 3
Cut a hole or a slot in the side to accommodate for the fixture's wiring and
place seal-a-light over the recessed light.
Battic Door Energy Conservation ‐ www.batticdoor.com ‐ 508 320 9082 ‐ [email protected]
Step 4
Using flame retardant grade foam, seal around all fours sides and the
hole/slot for wiring of the seal-a-light creating an air tight seal between the fixture and ceiling.
Our recessed light covers are intended for use on recessed light fixtures that are installed to manufacturer’s specifications using the correct wattage light bulb. We recommend using CFL light bulbs to reduce energy consumption.
Our recessed light covers are compatible with sprayed foam, mineral wool,
fiber glass and blown-in cellulose.