1. By adjusting the two bars (red and blue), find the perfect ratio between hot and cold water.

2. Then turn on the water by rotating the knob in the middle. At the first go, you would need some time to find the perfect temperature. However, once you find the "sweetspot" you won't have to do it ever again.

3. You can mark your "sweetspot" with a magnetic bar(green dots) so you can adjust to your settings right away.

01. 2 . 3 .

Quick-Temp Shower KnobPROBLEMOnly 25% of water is reproduced in Canada. Recycling or conserving water is

always important and there are chances to reserve water in household.

The goal of Quick-Temp is saveing water and improving shower experience.

Whenever you're taking a shower, you always end up letting water go down the

drain without use becuase the water would be too cold (or too hot).This goes on

until you hit the "sweetspot" that gives you perfect temperature and pressure.

Toilet tankGarden

Etc

Pipe for hot water

Shower Head

This part is where the water is get cold since it stays in pipe for a while. This water usually goes to drain without being used when users turn on hot water for a shower.

Pipe for cold water

When user rotate the knob in middle part when red and blue bars on zero, (Refer to diagram 1.above) the cooled water goes to another tank for toilet or garden.

Both pipes are ready to be used. Now it is time to adjust the ratio of hot and cold water, so you can use the water with temperature you want right away.

HOW TO USE