PF PNF TAXI & BEFORE T/O...PF PNF A330/A340-300 FLIGHT CONTROLS CHECK Rudder check “FULL UP”...

PFPF PNFPNFA330/A340-300

TAXI & BEFORE T/O

LR - Version 03b

PFPF PNFPNFA330/A340-3001. TAXI INITIATION

When Taxi clearance obtained:

NOSE LIGHT..………………………..………TAXI

PARKING BRAKE...............…………...……OFF

THRUST LEVERS……………………..AS RQRD

ANNOUNCE………………….”BRAKE CHECK”

BRAKE PEDAL……………………………PRESS

FLT CTL……………………………………CHECK

TAXI CLEARANCE..………………….…..OBTAIN

ELAPSED TIME ..............……….…..…AS RQRD

BRAKE PRESSURE......……….....CHECK ZERO

ANNOUNCE………………..”PRESSURE ZERO”

FLT CTL……………………………….….…CHECK

Before Taxiing:

NW STRG DISC……..CHECK not displayed onright ECAM MEMO

Observe ECAM MEMO :

PARKING BRAKE release

( Slight residual pressure may beindicated for a short period of time )

PFPF PNFPNFA330/A340-3002. TAXI : CLEARANCE CONFIRMATION

When ATC clearance obtained: ATC CLEARANCE……………………..CONFIRM

TERR ON ND……………………………AS RQRD

1. RADAR / PWS……………………...ON / AUTO

2. ATC…………………………………………..SET

3. AUTOBRAKE………………………………MAX

4. T/O CONFIG..…………………………...PRESS

5. T/O MEMO……..…………..CHECK NO BLUE

TCAS STBY

1 2

3

4

5

PFPF PNFPNFA330/A340-3003. TAXI CHECKS

CABIN REPORT…………………RECEIVE (CM1)

FCU ALT……..………………………………CHECK

If ATC requests to maintain runway heading or incase of a radar vector procedure :

HDG…………………………………………..…..SET

FLIGHT INSTRUMENTS….…………….….CHECK

T/O BRIEFING……………………………CONFIRM

FLIGHT INSTRUMENTS…………………..….…CHECK

BEFORE T/O C/L down to the line


If brake fans running:

BRAKE TEMP BELOW 150°C…….CHECK

BRAKE FANS……………………………OFF

TAKEOFF/LINE UP CLEARANCE………OBTAIN

ENGINE START SEL…………………....AS RQRD

TCAS…………………………………..TA or TA/RA

PACKS 1 + 2………………………….….AS RQRD

SLIDING TABLE………………………...…..STOW

4. BEFORE TAKE OFF

minimize bird strike hazardduring take-off

APPROACH PATH CLEAR OF TRAFFIC.…CHECK

CABIN CREW………………………………….ADVISE

EXTERIOR LIGHTS………………………………..SET

SLIDING TABLE………………………………...STOW

BEFORE T/O C/L below the line

PFPF PNFPNF………………

THE END...THE END...


FLIGHT CONTROLS CHECK

Rudder check

“FULL UP”

“FULL DOWN”

“NEUTRAL”

“FULL LEFT”

“FULL RIGHT”

“NEUTRAL”

“FULL LEFT”

“FULL RIGHT”

“NEUTRAL”

PF moves the flight controls

PNF announces :

Bothelevators

ailerons

PF checks that PNF calls are in accordancewith the sidestick orders

PNF applies full sidestick deflections andsilently checks full travels and correct sense




2. ATC…………………………………………..SET


4. TO CONFIG……………………………...PRESS

5. TO MEMO…………………..CHECK NO BLUE

1 2

3

4

5

FMGS updatesTAKEOFF DATA updates

- Gross Weight and CG on FUEL PRED- F-PLN (runway in use)- Flaps levers (Take-off position)- V1,VR,V2 (reinsert)- FLEX T/O temperature (reinsert)

If takeoff data / ATC clearance has changed, (or in case of RWY change)…

…update takeoff data and FMGS :

- F-PLN- Initial climb and speed limit





2. ATC…………………………………………..SET


4. T/O CONFIG..…………………………...PRESS


TCAS STBY

1 2

3

4

5

If use of radar is required, consider selecting theradar display on the PF side, and TERR ON NDon the PNF side only.





2. ATC…………………………………………..SET


4. T/O CONFIG..…………………………...PRESS


TCAS STBY

1 2

3

4

5

Switch the Radar ON and the PWS to AUTO aslate as possible to avoid hazardous emissions toground staff

Switch the Radar ON and the PWS to AUTO aslate as possible to avoid hazardous emissions toground staff





2. ATC…………………………………………..SET


4. T/O CONFIG..…………………………...PRESS


TCAS STBY

1 2

3

4

5

Set the appropriate ATC configuration for takeoff:

ATC: AUTOALT RPTG: ONATC code setTCAS: TA or TA/RATraffic sel: ABV

Set the appropriate ATC configuration for takeoff:

ATC: AUTOALT RPTG: ONATC code setTCAS: TA or TA/RATraffic sel: ABV





2. ATC…………………………………………..SET


4. T/O CONFIG..…………………………...PRESS


TCAS STBY

1 2

3

4

5

Autobrake may be armed with PARKING BRK ON.

Autobrake may be armed with PARKING BRK ON.

AUTO BRKMAX

ƌƌƌƌ ƌƌ ƌƌ

ƌƌƌƌƌƌ

ECAM WHEEL page





2. ATC…………………………………………..SET


4. T/O CONFIG..…………………………...PRESS


TCAS STBY

1 2

3

4

5

Check that ECAM upper display shows“T.O CONFIG NORMAL”

Check that ECAM upper display shows“T.O CONFIG NORMAL”


This disarms NAV mode.

Then RWY TRK will engage at 30 ft RA and will keep the aircraft on the current TRK.

This disarms NAV mode.

Then RWY TRK will engage at 30 ft RA and will keep the aircraft on the current TRK.

HEADING PRESET

Usual case :

If HDG preset :

CLB NAV

OP CLB

FMA

PFPF PNFPNFA330/A340-300Address any changes in the clearance

Make as extensive use as possible of the displays

T/O BRIEFING CONFIRMATION FLOW

Address any changes in the clearance

Make as extensive use as possible of the displays

T/O BRIEFING CONFIRMATION FLOW

TO BRIEFING CONFIRMATION

PERFpage

F-PLNpage

4

7 RWY/SIDGW

CONF

FLXSel ALT

V1

V2

VR( optional)

3

56

21

PFPF PNFPNFA330/A340-300limitation: 300°C

auto ignition temperature of the hydraulic fluid

BRAKE TEMPERATURE LIMITATION

Without brake fan: Rely on HOT BRAKE ECAM caution (triggered at 300°C)

With brake fans running:

The fans blow on the temperature sensor, and modifies the indication

The crew cannot rely on the ECAM caution (linked to indicated value).

Brake temperature must be checked

If indicated value is above 150°C: delay takeoff

Indication on ECAM : 150° CActual Brake temperature :300° C








PACKS 1 + 2………………………….….AS RQRD


4. BEFORE TAKE OFF






BEFORE T/O C/L below the line

Conditions for selecting IGN/START prior to takeoff :

Consider igniter’s wear in case of continuous ignition

Conditions for selecting IGN/START prior to takeoff :

Consider igniter’s wear in case of continuous ignition

ONENG ANTI ICE (not valid for RR and CFM engines)automatically

Heavy rain or severe turbulencesexpected after takeoff

Runway with standing water

CFMGEPWRR








PACKS 1 + 2………………………….….AS RQRD


4. BEFORE TAKE OFF






BEFORE T/O C/L below the lineKnown nearby traffic, in visual contact

Significant potential for unwanted or inappropriateresolution advisories

The FAA recommendsselecting TA mode








PACKS 1 + 2………………………….….AS RQRD


4. BEFORE TAKE OFF






BEFORE T/O C/L below the lineConsider selecting packsOFF or APU bleed ON

Improved performance(TOGA)

Reduced EGT (FLEX)

Use of APU bleed is not allowed, if wing anti-ice is to be used.

To avoid the ENG THRUST LOST ECAM warning :

t

APUbleed ON

Takeoff powerapplication

At least 20 sec.

Note: Select Packs OFF at least 20sbefore applying takeoff thrust.

PF PNF TAXI & BEFORE T/O...PF PNF A330/A340-300 FLIGHT CONTROLS CHECK Rudder check “FULL UP”...

Documents

Transcript of PF PNF TAXI & BEFORE T/O...PF PNF A330/A340-300 FLIGHT CONTROLS CHECK Rudder check “FULL UP”...