12/21/12 Petroleum refining engineering - Fixed Tube Sheet Exchangers; Leak & Hydrotest

1/2www.eng-tips.com/viewthread.cfm?qid=263646

Smart questionsSmart answersSmart people

Go Find A Forum Go

JoinDirectorySearchTell A FriendWhitepapersJobs

Home > Forums > Petroleum Engineers > Activities > Petroleum refining engineering Forum

Fixed Tube Sheet Exchangers; Leak & Hydrotestthread483-263646

frcreek (Petroleum) 25Jan10

11:55

Hi everyone;

My question is on the FIXED TUBE SHEET Exchangers (tube sheet is welded to the shell), particularly, identifying a leak and hydrotesting;

The normal way is to water test shell side and look for the leaky tube on the tube side of the exchanger. Then, plug it or replace it.

But when the Shell side design pressure is lower than Tube side design pressure, how a leak can be identified, fixed and hydrotested? the shell side testpressure will always be low, not enough to show any leak!

I do appreciate your insights,

Thanks,

Chance17 (Chemical) 25Jan10

12:51

I have had success finding tube leaks using shaving cream.Pressurize the shell side with air or nitrogen.Remove both channel covers.Coat the entire tube sheet with foamy shaving cream (both tube sheets).The leaking tube will blow out foam.If the unit is in the field, wind and rain may reduce the methods effectiveness.Also the method can be confusing if you have multiple leaks.

frcreek (Petroleum) 26Jan10

0:19

Thank you Yitbos for the response,

The issue is when the shell side design pressure is way lower than Tube side design pressure, say 5 bar vs. 30 bar.

I don't think pressurizing the Shell side would work!

Thanks,

unclesyd (Materials) 27Jan

tube manufacturerswww.watson-marlow.com/

tubing platinum-cured, pharma quality, lot code laser-etched

Share This

Search Here

12/21/12 Petroleum refining engineering - Fixed Tube Sheet Exchangers; Leak & Hydrotest

2/2www.eng-tips.com/viewthread.cfm?qid=263646

1022:42

If you know or pretty sure you have a leak you can use one of the following instruments to locate the offending tube/tubes while in place. I have used Ultrasonics and Helium Leak testing to locate leaks under similar conditions.

Pressure Testing

http://estgroup.cwfc.com/productsServices/spokes/01b_heatExchg_10-TubeTestingGuns.htm

Vacuum Testing

http://estgroup.cwfc.com/productsServices/spokes/01b_heatExchg_10d-650-TubeTestingGuns.htm

Prior to any hydrostatic testing we would do quick air bubble test to get the big ones.

We would then install the shell clamps and test the shell while watching the tubes. Add the channel sections and use pressure decay to hydrotest the tubeswhile watching the shell side.

texasmike45 (Mechanical) 23Feb10

18:07

I use an ultrasonic leak detector for pressure or vacuum leaks on heat exchangers, has worked well for me. Also helium testing.

http://www.uesystems.com/prod_up_2000.asp

Join | Jobs | Advertise | About Us | Contact Us | Site Policies

Copyright © 1998-2012 Tecumseh Group, Inc. All rights reserved.Unauthorized reproduction or linking forbidden without express written permission.

http://www.uesystems.com/prod_up_2000.asp

Home Loan at Lowest EMIHDFCInstantHomeLoans.com

Instant Home Loans from HDFC. Hassle Free Process & Great Rates