• Reduces efflorescence on both colored & standard concrete• Minimizes checking, crazing & scaling• Decreases potential for alkali silica reaction - *(ASR)

(e)Curling Reduction• Reduces potential for slab curling

Use It For• ALL trowelable surfaces• Interior & exterior• From warehouses to parking decks

Finish better and easier with DAY1 from Lythic Solutions. Thisnew type of troweling aid meets your most different finishingchallenges.• Extends finishing time from 15 to 45 minutes• Lubricates trowel - less wear on blades, less fatigue for

operator• Slows surface drying - closes better, finishing smoother

Don’t Lose The Slab

Features & AdvantageLythic DAY1 offers a multitude of advanced features and benefits for freshly placed concrete, and provides long-term high performance properties to treated concrete surfaces.

(a)Finishing Aid• Lubricates for more efficient closing of surface• Speeds finishing• Extends surface workability time by 15 to 30 minutes• Helps finishing under hot, dry, sunny & windy conditions• Reduces operator fatigue and trowel wear• Easier application of shake-on hardeners for concrete with high

air content / low bleed water environments

(b)Concrete Curing• Reduces Water Vapor Transmission Per ASTM F1869 -

(MVER)• Mitigates Volume of Water Vapors Per ASTM D 4263(c) Hardening & Densification• Increases abrasion resistance• Creates a denser, less permeable surface for resistance to

liquid penetration, staining• Increases impact resistance• Increases surface compressive strength approximately 20% -

30%(d)Efflorescence & Surface Defects• Colloidal silica chemical reaction reduces Ca(OH)2 migration

Power Troweling Aid and Curing Agent

It’s like having an extra

finisher on the job.

www.Ltfsolutions.co.in

Better Concrete Happens on

DAY1DAY1 Troweling Aid and Curing

Agent improves concrete during finishing.

Contractors describe DAY1“like having an extra finisher on the job.”TESTIMONIAL: Testing at Middle Tennessee State University (MTSU) of DAY1 as a Troweling Aid & Curing AgentRESULTS “The concrete with DAY1 was finished last, yet it came out the best, and I believed I could have even worked on it longer if I had needed to. There was very little resistance, and the concrete was still workable. I was able to use the power trowel with a lower pitch. All holes and low spots filled easily. There was no tearing of the fine aggregates, so the slab was easier to get on earlier and stay later without issues. I believed I could have troweled DAY1 sections only three times instead of four with the same results. And I could have waited longer before final finish if I wished, but that was unnecessary.”

~ Ed Kowalski, Quality Concrete & Conscapes

Finished with Lythic’s DAY1 Finished with water

For m

ater

iel &

In

form

atio

n Next Generation Concrete Systems Pvt. Ltd.S-9, Second Floor, Malik Buildcon Plaza-II, Pocket - 5, Plot No.6, Sector- 12, Dwarka, New Delhi - 110075 M : +91 84 708 54405 | T : 011 42804024E : info@ngcs.co.in | W : www.ngcs.co.in

Lamba Techno Flooring Solutions Pvt. Ltd.Q-27, Phase-I, Extn. New Palam Vihar, GurgaonM : +91 97 178 54400, 84 708 54401E : LTFSPL@gmail.com, info@Ltfsolutions.co.inW: www.Ltfsolutions.co.in

Note: When applying multiple times or using in combination with other colloidal silica treatments, total combined applications should not exceed (3.7L/m2)

NEXTGENERATION C O N C R E T E S Y S T E M S

Branch Offices: Delhi • Haryana • Rajasthan • Karnataka • Maharashtra • Gujrat

For

App

licat

ion

Application is simple:1. Spray on a modest amount and trowel into surface2. The power-trowel may speed up, because drag on

the blades is reduced by DAY13. It begins reacting instantly, and can slow down the

drying effects of wind, heat, low humidity and similar adverse

conditionsImprove Concrete During FinishingNow, you can improve the quality of your concrete right from the beginning. DAY1 gets troweled in during finishing and becomes a permanent part of the concrete, strengthening the slab and reducing water vapor transmission. DAY1 helps cure the slab, like a liquid membrane-forming curing compound, even though DAY1 does not form a membrane, lm or residue, and there is nothing to remove afterwards. DAY1 closes the pore structure near the surface, so water stays in the concrete longer, allowing for improved curing. To give your customers better concrete, DAY1 should be part of every troweled slab.

Don’t Add WaterWith DAY1, you don’t need to “bless the slab” with excess water to keep it workable. Water weakens the concrete and causes dusting. DAY1 strengthens the surface and prevents dusting.

DetailsDAY1 is shipped as a concentrate to reduce environmental impacts and shipping costs. It's easily mixed with water in a 4:1 ratio. Spray on and continue to finish the slab normally, but with less sweat.Working solution covers forFinishing Aid: …………………6-17 m2 / L & Performance Concrete: ………………..6-7.5 m2 / L

Important Note: Lythic Day 1 is designed to be floated or trowelled into the concrete surface. DO NOT Spray on theConcrete surface after troweling. Lythic Day1 is NOT a film forming cure for concrete.

For making Jointless floor we have adopted large area construction method as against conventional long strip casting, by this method large floors up to several thousand square metres in area was laid in a continuous operation. Fixed forms were used only at the edges of the construction at intervals of typically 30 X 24 m. Concrete was discharged into the floor area and spread by laser Screed machines. Levels were controlled both manually using a target staff in conjunction with a laser level transmitter and by direct control of laser-guided spreading machines constructing free-movement areas,

By definition Jointless floors are floors constructed in large panels typically 50 m square without intermediate joints.

http://ltfsolutions.co.in/