Precast Concrete Flooring Systems-680
Transcript of Precast Concrete Flooring Systems-680
-
8/3/2019 Precast Concrete Flooring Systems-680
1/9
precast concreteflooring systems
Hanson Building Products
precast concreteflooring systems
-
8/3/2019 Precast Concrete Flooring Systems-680
2/9
engineered solutions at every level
The range of pre-cast concrete flooring systemsfrom Hanson Building Products is one of the mostcomprehensive available in the UK today.
The original insulated flooring
system utilising expanded
polystyrene infill block. Ideal solution
to Part L requirements.
Cost effective suspended flooring
system comprising of inverted T
beams in filled with flooring grade
concrete blocks.
The range has been designed and developed to cover virtually everyconceivable structural flooring requirement in the domestic housing,and general construction markets.
All products are produced in quality controlled factory environmentsand are backed by a full range of support services including technicaladvice on product selection, project design assistance, installationadvice and on-site assistance. Effective nationwide logistics servicesensure that the product arrives on-site when it is needed.
Hanson is committed to the concept of partnership with customersand has in place the communication and financial proceduresnecessary to make this a reality.
Jetfloor Super Beam and block
-
8/3/2019 Precast Concrete Flooring Systems-680
3/9
jetfloor super
The first composite suspended system for ground
floors incorporating polystyrene infill blocks toprovide high levels of thermal insulation.
Integrated insulation means a reduced overallfloor zone, effectively reducing construction costs.
Rapid and easy installation. Installers benefitfrom speed and simplicity.
Floors can be finished early in the constructionprocess, allowing earlier drying out and fasterfollow-on for other trades.
Provides exceptional insulation, achieving
U-values as low as 0.20 (W/m2
K)
The system consists of standard
150mm deep inverted T beams at
a maximum of 610mm centres,
infilled with expanded polystyrene
(EPS) blocks. A grade 25 structuraltopping reinforced with A98 mesh
or polypropylene fibres completes
the system.
EPS blocks at 550mm in length
enable rapid coverage of large
floor areas.
Installation is simple and there is
no requirement for special skills,
equipment or preparation.
Services are easily accommodated
by omitting blocks or trimming
them with a fine toothed saw.
4
-
8/3/2019 Precast Concrete Flooring Systems-680
4/9
beam and block
The traditional and cost effective suspended
flooring system for ground and upper storeys.
SpecificationThe system consists of inverted
T beams infilled with standard
concrete blocks. The beams,
produced in standard profiles to
give nominal depths of 150mm
- 225mm, are manufactured in
50mm increments and are usually
placed at approximately 520mm
and/or 295mm centres dependingon span and load.
Beams are positioned perpendicularto the end supports with a nominal
bearing of 100mm to each end
when supported by brick or block
work. A 75mm minimum bearing is
required when supported by
steelwork.
Initial spacing is achieved by infill
blocks at each end and the flooring
grade blocks are inserted from
above between the beams.
The completed floor is then grouted
using a 4:1 sharp sand/cement
mixture.
Economical in use in all types of construction.
Fast and easy to install.
Unaffected by damp, rot or vermin.Allows longer spans than can be achievedwith timber joists, often eliminating theneed for intermediate foundations.
6
-
8/3/2019 Precast Concrete Flooring Systems-680
5/9
hollowcore flooring units
Prestressed hollowcore units are the ideal solution
for all suspended floor applications especiallywhere a clear spanning durable deck is required.
The Hanson range of hollowcoreunits is now the most extensive
available to the UK market. Units
are manufactured in a range of
widths increasing the versatility
and scope of the product and
enabling flooring solutions to be
tailored to specific projects. All units
are designed in accordance with
BS 8110 and are prestressed
during manufacture.
When concreted together
hollowcore units can provide
diaphragm action without structural
topping, but enhanced structural
performance is achieved by using
a composite structural topping.
Clear, unpropped spans up to 13.0m
Can be used on masonry, steel or concrete
structuresFast to erect and units provide an immediateworking platform
Service holes and notches can be preformed
Excellent sound and fire resistant properties
Loadspan information can be downloaded from the website - www.hansonprecast.com
or is available from the relevant technical department.
8
-
8/3/2019 Precast Concrete Flooring Systems-680
6/9
-
8/3/2019 Precast Concrete Flooring Systems-680
7/9
staircases and landings
Hanson pre-cast stairs and landings can be
designed and manufactured to suit the requirementsof most domestic and commercial projects.
Hanson now offers a
comprehensive range of
standard moulds for
staircases and landings
capable of meeting the
requirements of mostprojects.
Aids rapid construction
Straightforward installation no propping or expensive formwork
Suitable for virtually any situation in masonry,steel or concrete buildings
Allow immediate access for follow-on trades
Inherent fire resistance
Factory produced qualityand accuracy
12
-
8/3/2019 Precast Concrete Flooring Systems-680
8/9
manufacturing facilities and services
Hanson pre-cast flooring products are
manufactured at four modern productionplants in the UK.
Housing and
Accommodation projects
Hoveringham Office
Tel 01636 832000
Fax 01636 832020Ipswich Office
Tel 01473 461771
Fax 01473 464117
Commercial and Non
Accommodation projects
Alfreton Office
Tel 01773 602432
Fax 01773 603134
Omnia Projects
Washington Office
Tel 0191 417 0066Fax 0191 417 0131
Enquiries
Precast
flooring
production
facilities
Manufacture
All products are manufactured in
accordance with relevant
British/European/Trade Association
standards. All sites are quality
assured to BS EN ISO9001.
Design and
Installation services
Hansons experienced
engineering design teams provide
expert assistance on all projects
and we will also advise and
assist with installation where
required.
Comprehensive information on
the complete range of products
will be found at
www.hansonprecast.com
and www.omnidec.co.uk
Loadspan information can be
downloaded from the website
or is available from the relevant
technical department.Washington
Alfreton
Hoveringham
Ipswich
14
-
8/3/2019 Precast Concrete Flooring Systems-680
9/9
Floors and Precast Division
0870 6097094
Hanson Building Products
Head Office
StewartbyBedford
MK43 9L2
Tel: 08705 258258
Website: www.hanson.biz