ORI GA NOW IN THEATERS MI O - CandypoloozaO U DI D T! Unfold the paper lengthwise so that the flaps...
Transcript of ORI GA NOW IN THEATERS MI O - CandypoloozaO U DI D T! Unfold the paper lengthwise so that the flaps...
©2015 DISNEY/PIXAR
NOW IN THEATERS ARLO
ORIGAMI
1 2 3 4
5 6 7 8
9 10 11
On the back side of a square piece of paper,
fold in half diagonally both ways to make
two long creases from corner-to-corner.
Unfold back to original square.
Fold in bottom-left and bottom-right
paper edges to line up against the center
crease.
Turn paper over. Fold up the narrow bottom corner to meet
the top corner.
Turn paper over. Pull down inner corner and press down at
the existing crease – at the same time,
fold in the top-right paper edge to line up
against the center crease.
Repeat on the opposite side. Fold up the bottom two triangle flaps at
the fold line indicated in the above
diagram, lining them up against the
center line.
Unfold the back flap. Fold the right corner down at the fold line
indicated in the above diagram, lining up
against the center crease. Unfold to create
a crease.
Fold in half lengthwise (at the long center
edge) with the flaps side facing out.
©2015 DISNEY/PIXAR
NOW IN THEATERS
ARLO
ORIGAMI
12 13 14 15
16 17 18 19
20 21 22
YOUDIDIT!
Unfold the paper lengthwise so that the flaps
side is now facing away from you.
Fold up the bottom corner against the fold
line indicated in the above diagram.
Fold inward left and right corners at #1
and #2 fold lines indicated above. Fold up
bottom edge at #3 fold line indicated
above, then unfold the entire center
triangle making sure not to unfold #3
section.
Turn paper over.
Pull up two bottom corners making
small folds at lines indicated above,
Fold paper inward at dark areas
indicated above to form the “legs.”
Fold in half lengthwise with
flaps side facing out.
Fold down small triangle flap at fold
line indicated in above diagram.
Repeat on opposite side to form the
remaining “legs.”
Unfold lengthwise with flaps side facing up.
Fold top section in half inward, then re-fold
lengthwise to flatten “neck” downward.
Unfold lengthwise with flaps side facing up. To complete the
“neck,” make two small folds at the bottom of the “neck” and
fold back in half, pushing paper inward at dark areas.
Re-fold lengthwise again to flatten “neck” upward.
To form the “head,” fold/tuck in the top corner
along the fold line indicated above.
Looking at the back of the “head” (see circle
diagram), pull down #1 and #2 corners, pushing
paper inward at dark areas indicated above, and
re-fold lengthwise at #3 fold line to flatten “head.”