I ~(? I H 'J64~B

s"p· '(;-2...

!1/)el/eS go') 0LJ:::- 2737 bt-.II'-e' r""cbl1~e.-lcI '7 t eJ (., 03> :s / C;~

------·WARNING 1-' ------READ BEFORE USING LASER

1) This unit l~ wired to operate at lIS- Volts.

2) Air inlet and outlets must not be obstructed . The laser is not designed to sit flat on a table during operation. The laser will lJe unstLlblc and ultimate ly shut off if the air flow is blocked. Mount laser in brackets provided.

3) Save the original cartons in case it is necessary to ship the unit back to Omnichrome. These cartons were carefully designed to prevent breakage during shipment. Unit returned in any other carton may void warranty.

4) Turn On: With keyswitch in "ON" position, turn rotary switch to "OPERATE" position. Laser output starts approximately two (2) minutes after the rotary switch is turned on, and stabilizes approximately four (4) minutes after turn on.

Shut Down: Do not use key switch to turn laser off. Key switch is for emergency only. Turn laser off by switching rotary switch

. to shutdown position. Laser output will continue 1 to 2 minutes after the rotary switch is turned off.

Restart: Restarting is locked out by the power supply if the red "Temp Lock Out" light in ON. Leave the rotary switch ON and the fan will cool the laser tube to an acceptable temp. Level, at which time the laser will automatically relight.