Motion sensor LED tube

18w Motion sensor LED tube T8

Description:

Motion sensor LED is an intelligent

LED tube that can be automatically

dimmable by inducting the thermal

radiation from body or the car in

order to save more energy, and is

widely used for underground parking,

warehouse, tunnel lighting and other

places.

Specification:

Input voltage AC85~265/50~60HZ

Rated power 18watts

Min power 3watts

Color temperature 5500-6500k(frosted cover)

Cover type Frosted/clear/stripe

Base type G13 medium Bi-pin

Dimension D26*L1200mm

Luminous flux 1650lm(frosted cover)

Inductive beam angle 120°

Inductive distance 6~10meters

Inductive overtime 25~30s(factory set)

Reaction time 0.5s

Power factor 0.95

Work temperature -20℃~55℃

Remark:

Inductive overtime can be customized according to your requirements.

How it works?

When the car or a person enters in the sensor area, the infrared LED tube will be full light, the power will

be 18watts,then,lasting lighting for 30seconds,then,becoming dark, and the power will be 3watts after

the motion is from the sensor area.

Remark: motion sensor led tube is not workable in the fixture with Cover.

(workable) (unworkable)

Installation guide

Warning: risk of electric shock! Ensure that the power supply is off when wiring sections

of this device. This device is to be installed by a qualified electrician or technician in

accordance with all relevant local codes. Please read this user guide completely prior to

installation and please pre-plan the installation.

Note: please remove Bi-pin shipping protectors from end of tubes prior to installation

Unpacking

1. Unpack and carefully examine the product

2. Report any damage and save all packing materials if any part is damaged during transport

3. Do not attempt to use this apparatus if it is damaged

Before you start: Installation of your new LED tube is simple, but requires a basic knowledge of

wiring (as shown below).if you do not feel comfortable with this type of wiring, Okuhlaza Energy

would recommend consulting a qualified electrician.

Note: please ensure that power is disconnected from fitting before installing LED tube

Wiring with Magnetic ballast

For a single tube, the magnetic ballasts do not need to be removed, if the installation has multiple

tubes, then the ballast must be removed, to maximum energy saving, it is recommended to always

remove the ballast, the preheat/starter lamp should be removed when used with an LED tube

Wiring with Electronic Ballast

You should not use an LED tube with electronic ballast. Remove or bypass the electronic ballast prior

to installation, to avoid damage to the LED tube.