Landcruiser Castor Bush
Transcript of Landcruiser Castor Bush
-
8/19/2019 Landcruiser Castor Bush
1/1
(Check tension of bolts after 500km) 8. Re-install arms to vehicle, and perform wheel alignment.
80mm.
5. Position front bush with small notchin line with your vertical line on arm and
press front bush into arm.
6. Align and press rear bush into
1. Mark Radius Arms here, vertical to level ground, in line with centre of bush before
A4 Scale 1:1
raising vehicle.
arm ensuring distance between7. Ensure bushes in both arms are identical.
centres is 185mm±0.5mm.
(Lay arms together to verify)
2. Remove arms from vehicle.
3. Press out original bushes.
4. Lay Radius Arm on this template for hole positions.
This template is suitable for 50mm Lift.
For lifts other than 50mm, your vertical linemay be positioned different to this template,in such a case, use your vertical line anddisregard this template.
Not suitable for vehicle lifts greater than
SK
185mm
for 50mm Lift
FRONT
TOYOTA LANDCRUISER76,78,79,80,105 Series
Offset Castor Correction Bushes2°
Increase