Toyota Landcruiser 100 series 6 cyl
Transcript of Toyota Landcruiser 100 series 6 cyl
270121.4
L.P. GAS CYLINDER
INSTALLATION INSTRUCTIONS
TOYOTA LANDCRUISER – 100 SERIES (6 CYL ONLY)
260dia Twin Endfill Cylinders
This Automotive LP Gas cylinder must be installed in the vehicle in strict accordance with the latest requirements of
AS/NZS1425.
General Cylinder Specifications: (2 cylinders per vehicle)
DIAMETER : 260mm LENGTH : 900mm
WATER CAPACITY : 43L L.P GAS CAPACITY : 34.4L
VALVE ORIENTATION : Endfill
Installation:
1). Install the filler and filler hoses to the vehicle as directed.
2). Place vehicle on hoist and remove the front 3). Fit the attachment brackets supplied by
brackets supporting the side step on both . Manchester Tank to both of the side steps.
the left and right hand side of the vehicle. Note: The cylinders will not fit in place
without changing the side step brackets
4). Fit the brass ‘T’ piece supplied with the filler 5). Jack the left hand cylinder into position
to the left hand cylinder as shown. Note the in between the side of the vehicle and the
relief valve location when determining the main chassis. Ensure the valve is facing to
left hand cylinder. Fit the 90deg brass elbow the REAR of the vehicle.
supplied to the right hand cylinder.
6). Included with the cylinder is a bolt pack 7). Bolt the cylinder to the side of the chassis
containing bolts, washers, nyloc nuts, placing the crush tube between the cylinder
crush tubes and powder coated backing plates. bracket and the backing plates
8). When bolted in place, check the cylinders are
not making contact with either the chassis or
the floor pan of the vehicle. Repeat steps
5 – 8 for right hand cylinder
9). Connect the filler hoses to the cylinders as per AS/NZ1425 requirements
Should you encounter any difficulties with the installation of these cylinders, please contact your LPG Equipment distributor.
Do not remove the valves without authorisation from Manchester Tank.