Introduction to Advanced Design System (ADS) by Agilent Technologies
Transcript of Introduction to Advanced Design System (ADS) by Agilent Technologies
Introduction to Advanced Design System (ADS) by Agilent
Technologies
Benjamin Braaten
ECE Department
North Dakota State University
Starting ADS – type in the title of the project and click “OK”.
Make sure the project name ends in “_prj”!
Starting ADS – After clicking “OK” you will get the following screen. Press “cancel” and
close the “Schematic” window.
For this example we will simulate the following filter:
Substrate: grounded FR4Permittivity = 4.25
Loss Tangent = .003Thickness = 1.76 mm
LayoutFirst define the substrate
Opens the followingwindow
Define the substrateproperties in thiswindow
Layoutdefine the layout layers
Next, define the layout layers
Click “strip” when adding layer up here
Click “OK” when finished
LayoutNext, define the source position.
Define port positionand left click tosnap to conductor.
Do the same for both sides.