INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY
Transcript of INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY
![Page 1: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/1.jpg)
Facilitators: -Dr. B. M. Gurupadayya,Dr. R. S. Chandan,Dept. of pharmaceutical chemistry,JSS college of pharmacy,Mysore.
Submitted by: -Ram Mohan S.R.
1st M.Pharm
Pharmaceutical Quality AssuranceJSS college of pharmacy
Mysore.1
![Page 2: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/2.jpg)
Nebulizer
Flame
Burners
Mirrors
Slits 2
![Page 3: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/3.jpg)
This is the component of sample delivery system. which breaks up the bigger liquid droplet to smaller liquid droplets.
The process of conversion of sample to a fine mist of finely divided droplets using a jet of compressed gas is known as Nebulization.
3
![Page 4: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/4.jpg)
Pneumatic nebulizers
Electro thermal vaporizer
Ultrasound nebulizer
4
![Page 5: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/5.jpg)
PNEUMATIC NEBULIZERS
CONCENTRIC TUBES
CROSS FLOW
BAGINGTON
FRITTED DISK
5
![Page 6: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/6.jpg)
The liquid sample is sucked through a capillary tube by a high pressure jet of gas flowing around the tip of the capillary.
The high velocity breaks the sample into a mist and carries it to the atomization region.
6
![Page 7: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/7.jpg)
The jet stream flows right angles to the capillary tip.
It uses a high speed stream of gas perpendicular to the tip of the sample capillary
7
![Page 8: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/8.jpg)
The jet is pumped through a small orifice in a sphere on which a thin film of sample flows
In this type of nebulizer the sample solution flows freely over small aperture, rather than passing through a fine capillary
8
![Page 9: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/9.jpg)
The sample is pumped into a fritted disk through which the gas jet is flowing and this gives fine aerosol than others
High efficiencies can be obtained by introducing the sample at predetermined location of the fritted surface
9
![Page 10: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/10.jpg)
It is an electro thermal vaporizer contains an evaporator in a closed chamber through which an inert gas carries the vaporized sample into the atomizer
10
![Page 11: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/11.jpg)
The sample is pumped onto the surface of a vibrating piezoelectric crystal.
The resulting mist is denser and more homogeneous than pneumatic nebulizers
11
![Page 12: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/12.jpg)
12
![Page 13: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/13.jpg)
It should have proper temperature
Temperature should remain constant throughout the operation
There should not be any fluctuation during burning
To convert the analyte of the liquid sample into vapour state To decompose the analyte into atoms and simple moleculesTo excite the formed atoms/free atoms/simple molecules to emit radiant energy
13
![Page 14: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/14.jpg)
Mecker burner
Total consumption
burner
Premix of laminar flow
burner
Lundergraph burner
Shielded Burner
Nitrous Oxide-
Acetylene Flames
14
![Page 15: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/15.jpg)
This burner was used earlier and employed natural gas and oxygen. Produces relatively low temp. and low excitation energies. This are best used for ALKALI metals only. Now-a-days it is not used.
15
![Page 16: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/16.jpg)
In this burner fuel and oxidant are hydrogen and oxygen gases. Sample solution is aspirated through a capillary by high pressure of fuel and Oxidant and burnt at the tip of burner. Entire sample is consumed.
16
![Page 17: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/17.jpg)
In this type of the burner, aspirated sample, fuel and oxidant are thoroughly mixed before reaching the burner opening and then entering the flame. There is high loss of sample(95%) as large droplets which are drained out.
17
![Page 18: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/18.jpg)
In this sample and air is mixed in a chamber, this mixed composition is send to fuel nozzle where it is atomized. Here the sample reaches the flame is only about 5%
18
![Page 19: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/19.jpg)
In this flame was shielded from the ambient atmosphere by a stream of inert gas. Shielding is done to get better analytical sensitivity and quieter flame
19
![Page 20: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/20.jpg)
These flames were superior to other flames for effectively producing free atoms. The drawback of it is the high temperature reduces its usefulness for the determination of alkali metals as they are easily ionized and Intense background emission, which makes the measurement of metal emission very difficult
NITROUS OXIDE ACETYLENE FLAME
20
![Page 21: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/21.jpg)
Fuel Oxidant Temperature 0C
Natural gas Air 1700-1900
Natural gas Oxygen 2700-2800
Hydrogen Air 2000-2100
Hydrogen Oxygen 2550-2700
Acetylene Air 2100-2400
Acetylene Oxygen 3050-3150
Acetylene Nitrous oxide 2600-2800
21
![Page 22: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/22.jpg)
The radiation from the flame is emitted in all the directions in space. Much of the radiation is lost and loss of signal results. A mirror is located behind the burner to reflect the radiation back to the entrance slit of the monochromator. The reflecting surface of the mirror is front-faced.
22
![Page 23: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/23.jpg)
The entrance and exit slits are used before and after the dispersion elements.The entrance slit cuts off most if radiation from the surroundings and allows only the radiation from the flame and the mirror reflection of flame to enter the optical system.The exit slit is placed after the monochromator and allows only the selected wavelength range to pass through the detector
23
![Page 24: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/24.jpg)
Chatwal & Anand; Instrumental Methods of Chemical Analysis, 5/e 2013, page no- 2.370 to 2.375, Himalaya Publishing House.
B.K Sharma; Instrumental Methods of Chemical Analysis, 26/e 2007, page no- 430 to 437, GOEL Publishing House.
24
![Page 25: INSTRUMENTATION OF FLAME EMISSION SPECTROSCOPY](https://reader030.fdocuments.in/reader030/viewer/2022013111/559bef561a28ab2a1b8b4652/html5/thumbnails/25.jpg)
25