Installing VMware & the Data ONTAP Simulator

SE Technical Academy

Installation Overview

Copy the trial version of vmware™– When you return to your office you should request

approval from your manager for a fully licensed version. You will be able to just plug in the serial number once you receive it. You will not have to reinstall.

– http://se-web.corp.netapp.com/cgi-bin/form_engine/form_engine.pl/se_tools/iwant/index.html?conf=vm_license

Install vmware

Copy the Linux Image

Setup the simulator

Create a Directory on your machine

Create a directory somewhere on you machine called SETA

Copy all the files from the CD (provided by your instructor) to this new folder.

Double-click VMware-workstation-5

Double-click the VMware-workstation-5.Temp.exe to begin the VMware installation.

Accept all the defaults for the installationEnter the Serial #, Click Finish

Accept all the defaults for the VMware installation.

When prompted open VMWare_Temp_License.doc for the temporary Serial Number.

Double-click the RH_Linux9.exe file. Browse to My Virtual MachinesUnzip

Double-click RH_Linux9 folderDouble-click RedHat_Linux9.vmx

Add this VM to your favoritesVM | Add to Favorites

Set the CD-ROM iso fileFollow the 7 steps, then click OK

1

2

3

4

5

6

7

Start the virtual machine

1

If you get either of these messages,Click OK

Start the virtual machineKeep the existing identifier

2

It may take a minute to look like this.Enter your login and password

Login: root

Password: netapp

Login: root

Password: netapp

Note: Use Ctrl-Alt to move in and out of the simulator window.

Note: Use Ctrl-Alt to move in and out of the simulator window.

Issue the following commands to mount the CD drive & begin simulator installation

Accept defaults except where noted.

Accept defaults except where noted.

Continue Simulator InstallAdd 11 disks

Accept defaults except where noted.

Accept defaults except where noted.

As much as you have room for, in this case 11 Gigabytes

Simulator Installation Complete

Starting the Simulatorcd /sim./runsim.sh

Hostname[]: Enter Something Heretimezone [GMT]: US/Pacific New password: netapp

netappnetapp

Accept defaults except where noted.

Accept defaults except where noted.

Note: Hostname will show up as your CLI prompt “filer70>” in this case.

Defaults, netapp and 2 for Workgroup authentication.

netappnetapp

Accept defaults except where noted.

Accept defaults except where noted.

Defaults and set another password

netappnetapp

Accept defaults except where noted.

Accept defaults except where noted.

Congratulations! You have a filer, a simulated filer that is.

netapp

Accept defaults except where noted.

Accept defaults except where noted.

Press the Enter key.

ifconfig –a To get your IP address for you filer

http://ipaddress of filer/na_adminLaunches FilerView for your simulator

User: root

Password: netapp

User: root

Password: netapp