Installation Procedure: EVC-E D11 & D13...
Transcript of Installation Procedure: EVC-E D11 & D13...
To next station To next station
IMPORTANT! This end of Y-connector must be connected directly, without extension, to levers/HCU.
Y-connector
Multiple helm stations
Helm station
Helm station
8
8
7
8
8
Engine Engine
8
11
11 11
7
11
Multisensor
Installation Procedure: EVC-E D11 & D13 InboardInstallation Procedure: EVC-E D11 & D13 Inboard
Document number: 47702216
Release date: 06-2012
NMEA interface
ADU
Multilink hub
Multilink hub
Multilink hub
Buzzer
Multifunction panel(Start/Stop panel)2.5” displays
2.5” display
Levers
Levers
Lever connections
Lever connections
Lever
Lever connections
Buzzer
Connection for safety lanyard
Buzzer
Connection for safety lanyard
Rudder angle sender
Rudder angle sender
Fresh water and fuel level senders
Fresh water and fuel level senders
Engine Engine
Engine
FlybridgeD11/D13, twin engine installation
Typical installation / Main stationD11/D13, twin engine installation
ControlsTypical installationD11, single engine installation
IMPORTANT! Never cut or modify the Volvo Penta EVC harnesses. For extra power supply, use the Volvo Penta relay for external accessories.
Use template when making holes in dash-board
Use cable ties to fix cables
Multilink minimum requirements:
NOTE! Minimum one 2.5” display per driveline or one 4” or 7” display.Maximum two 7” displays on one helm station.
Additional multilink features:
Reverse gear connections
Engine connections
Standard–right hand rotation: Connector PRIMARY to solenoid P Connector SECONDARY to solenoid S
Trolling
Rev. pick-upSecondary (S)Primary (P)
Primary (P) PAD 10/11
Oil temp./pres-sure
ZF305, ZF311, ZF325, ZF335
MGX5096
Connecting multiple Multilink hubs
OK!
For information on cable lengths etc. please refer to Installation manual.
NOT OK!
10
1 12
10
16
19
9
7
7
12
1
Safety wire
Hull
Marine sealant
Multisensor
e-Key panel
1010
1610
10
11
10
1010
11
7
10
12
10
AUXTermination plug
25
10
5Termination plug
12
3
21 21
77 5 Termination plug
7
7
OK!
25
5
AUX-bus termination
Termination plug 5
e-Key panel
Termination plug
Incorrect!No end termination of the AUX-bus
Correct!Termination in the beginning and at the end of the AUX-bus
e-Key Remote (optional)
Locking/unlocking the boat system. Controls main circuit breaker and two aux relays
e-Key (standard)
Locking/unlocking the boat system
e-Key System
5
Battery Management Negative terminal
Starter motor
Remote frequency reciever with WLAN (RFW)
Continuous output 20 A
B: fused output
A: unfused output
House loads2.5” Battery Management display
Battery sensor
To engine connector (AUX)To external switches (optional)
Termination plug
5
MGX5114
Secondary (S) PAD 14/15
Secondary (S) PAD 14/15
Primary (P) PAD 10/11
Battery Control Unit (BCU)
Battery Control Unit (BCU)
Battery sensor Battery sensor
D13
DATA
LINK
SEN
DER
S
AU
X BU
S
AU
X BU
S
D11
AUX BUS
DATALINK
SENDERS
AUX BUS
ENGINE CONN.
DIAGNOS
2.5” displays7” display 4” display
2.5” Battery Management display
7
Remote frequency reciever
with WLAN (RFW)
Battery Control Unit Battery sensore-Key
Components
Stand-alone HCU e-Key panel
Ignition, start/stop and locking/unlocking the boat system
Multilink hub
6 cable sockets
NMEA 0183 interface NMEA 2000 interface
Fresh water level **
Diameter 52 mm (2.05”)
EVC system tachometer
Diameter 85 mm (3.35”) 110 mm (4.33”) 0–4000 rpm
Coolant temp **
Diameter 52 mm (2.05”) C°, F°
Speedometer Unitless **
Diameter 85 mm (3.35”) 110 mm (4.33”)
0–40 1/Hour 0–60 1/Hour
Alarm instrument **
Diameter 52 mm (2.05”)
Voltmeter **
Diameter 52 mm (2.05”) 12 V, 24 V
Rudder indicator **
Diameter 52 mm (2.05”)
Front ring kit (nut)
Diameter 52 mm (2.05”) Black/Chrome
Diameter 85 mm (3.25”) Black/Chrome
Diameter 110 mm (4.33”) Black/Chrome
Front ring kit (clamp)
Diameter 52 mm (2.05”) Black/Chrome
Diameter 85 mm (3.25”) Black/Chrome
Fuel level **
Diameter 52 mm (2.05”)
Engine oil pressure **
Diameter 52 mm (2.05”) bar, psi
Turbo pressure **
Diameter 52 mm (2.05”) bar, psi
4-in-1 Gauge **
Diameter 110 mm (4.33”) Coolant temperature Voltage Oil pressure Fuel level
Aux. Dimmer Unit (ADU) **
7” display power supply for 12 V systems
Multisensor
Transom mounted
A-CAN
Analog lever interface
Multisensor
Hull mounted
Sender
Fuel level sender 3–180 ohm
Fuel level sender 240–30 ohm
Sender
Water level sender 3–180 ohm
Instruments**) Only in combination with EVC system tachometer
2.5” display
Not in combination with 4” or 7” display
7” display
Color display
4” display
Color display Not in combination with 2.5” or 7” display
Not in combination with 2.5” or 4” display
Rudder angle sensor
3–180 ohm
e-Key Remote
NMEA interface
ADU16 161010
10
Multifunction panel
Function configured at startup
47
70
22
16 0
6-2
012
Components and Cables
Controls
Cables
Twin engine levers
Built-in HCUs
Single engine lever
Built-in HCU
1. Wiring harnesses, D11/D13
D11 ZF Feet Meter Part no. 1 0.3 21855159
D13 ZF 0.7 0.2 21769586
D13 MGX 1.6 0.5 21776653
2. Multisensor Y-split*
Feet Meter Part no.
1.9 0.6 21825662
*) Wiring harness AUX-bus.
3. BM-display Y-split*
Feet Meter Part no.
1.9 0.6 21825656
*) Wiring harness AUX-bus.
19. Display cable, 5/6-pin
Feet Meter Part no.
5 1.5 21640400
Incl. in display kit
21. Battery sensor cable
Feet Meter Part no.
9.8 3 21840060
8. Y-connector, 6-pin
Feet Meter Part no.
1.6 0.5 3588972
10. Multilink cable, 6-pin
Feet Meter Part no.
5 1.5 3886666
11. Extension cable, 6-pin
Feet Meter Part no.
5 1.5 3889410 10 3.0 3842733 16 5.0 3842734 23 7.0 3842735 30 9.0 3842736 36 11.0 3842737 66 20.0 21172469 131 40.0 21172470
16. Extension cable, 3-pin
Feet Meter Part no.
3 1.0 874759 10 3.0 3807043
12. Sender cable, 6-pin
Feet Meter Part no.
16 5.3 3807229
17. Steering adapter, 12/6-pin
Feet Meter Part no.
0.6 0.2 21421945
15. Extension cable, 6-pin
Feet Meter Part no.
5 1.5 21480272
13. Aux. relay cable, 6-pin
Feet Meter Part no.
3.3 1.0 21427463
Kit with cable & relay 12V: 21475508 24V: 21475509
14. Extension cable, 6-pin
Feet Meter Part no.
23 7.0 21166002 30 9.0 21166003 43 13 .0 21166004
18. Y-split multilink, 6-pin
Feet Meter Part no.
1.6 0.5 3588206
5. Termination plug
Part no.
21825714Single engine lever
Built-in HCU
Side mounted
7. Standard EVC bus cable, 6-pin*
Feet Meter Part no.
5 1.5 21865234 16 5.0 874789 23 7.0 889550 30 9.0 889551 36 11.0 889552 42 13.0 888013
*) One cable per engine has to be ordered.
9. 7” display cable, 6-pin
Feet Meter Part no.
5.5 1.7 21514712*
*) Incl. in display kit
25. e-Key harness with Safety lanyard
Feet Meter Type Part no.
5 1.5 Single panel 21693202 5 1.5 Twin panel 21693206
26. e-Key harness without Safety lanyard
Feet Meter Type Part no.
5 1.5 Single panel 21693204 5 1.5 Twin panel 21693208