Management requires measurement: Reducing flood damage by improving response time
Inspection Tools -Container Damage Measurement, Survey Tools - Container Damage Measurement _...
3
We design and supply specialise measurement tools for use in the inspection of ISO general cargo containers. Our tools makes it easy for inspectors to perform damage inspection on containers with speed, accuracy and safety. Our tools are designed to be used for all the common inspection criterias such as IICL, UCIRC, CIC and other seaworthy criterias. 1. Measure side panel out of ISO+40mm (UCIRC) using 2040 measuring gauge 2. Measure roof panel dent with the roof corrugation end dented using measure back method Point of dent to be measured is approximately 19cm. from edge of panel. Place the gauge onto both top side rails and set the reference line. Measure the deepest point of the dent. Inspection Tools Home (http://www.containersurveytools.com) Inspection Tools Navigation (http://www.containersurveytools.com) + 603 31766040 (tel:60331766040) Contact Us (/contact/) /
description
ISO Container
Transcript of Inspection Tools -Container Damage Measurement, Survey Tools - Container Damage Measurement _...
-
We design and supply specialise measurement tools for use in the inspection of ISO general cargocontainers. Our tools makes it easy for inspectors to perform damage inspection on containers withspeed, accuracy and safety. Our tools are designed to be used for all the common inspection criteriassuch as IICL, UCIRC, CIC and other seaworthy criterias.
1. Measure side panel out of ISO+40mm (UCIRC) using 2040 measuring gauge
2. Measure roof panel dent with the roof corrugation end dented using measure back method
Point of dent to be measured is approximately 19cm. from edge of panel. Place the gauge onto bothtop side rails and set the reference line. Measure the deepest point of the dent.
Inspection Tools
Home (http://www.containersurveytools.com) Inspection Tools
Navigation
(http://www.containersurveytools.com)
+ 603 31766040 (tel:60331766040) Contact Us (/contact/) /
-
Then measure the opposite end (or an adjacent corrugation) of undamaged portion of roof alsoapproximately 19cm from the edge of panel. The difference between the 2 measurements would bethe actual depth of the dent.
3. Measure front panel IICL out of ISO+ 5mm
If the panel is in contact with the reference line the bulge is damage exceeding IICL ISO+ 5mmcriteria.
4. Measure cross member bow & bent using Twin tower gauge with no need to place the uniton stand and no need to go underneath the lifted unit to take measurement
If lower part of flange in contact or exceed reference line, component is damaged exceeding IICL outof ISO 15mm
-
If bent web in contact with reference line, component is damaged exceeding IICL 50mm or UCIRC75mm criteria
5. Measure panel dents from inside of the container using the Twin tower
From interior, if panel in contact with reference line, panel is damaged exceeding IICL/CIC 35mm orUCIRC 50mm
Copyright 2014. All Rights Reserved. 2040ITS Sdn Bhd. - designed by BJWeb.com (http://www.bjweb.com)
2040ITS SDN BHD109A, Lintang Sultan Mohammad 1B
Bandar Sultan Suleiman
42000 Port Klang
Selangor, Malaysia
Tel: +603 - 3176 6040Fax: +603 - 3176 3040
Email: [email protected]
Contact Us
