HYDROPONICS How to Raise and Lower the Lampshade GARDEN ...

3
HYDROPONICS GARDEN KIT Setup Guide How to Raise and Lower the Lampshade Operation procedure Included in Package tank or change water pump. 3. Never operate garden kit if it has a damaged cord or plug, if it is not working properly, if it has been dropped and damaged, or if it has been dropped in water. If any of these conditions occur/exist, contact email: 5. This product is intended for household and resdential use only. Do not use outdoors. 6. Do not allow water to contact hot LED Grow Lights. water or other liquid to clean it. directly submerged to water. If any water is spilled or scattered over 9. This appliance is not intended for use by persons (including children) with the appliance. pump. 1. Plug Adapter 2. Sponges 3. Basket Kit To raise the Lampshade, press one hand around the bottom of the hand. Push up to raise the Lampshade. To lower the Lampshade, press down the Lampshade with one hand. Tips: When planting a new seed pod kit, the Lampshade should be set to the lowest possible position. Take out the lid of the water tank. Use tap water or bottled distilled water. For best results, keep the water level between 4.5 liters and 5 liters. water, shaking until well mixed. water, shaking until well mixed. Add 25 milliliters A solution and 25 milliliter B solution when adding 5-liter water to the tank. Note: milliliter B solution. For best results, top off the water level in your garden regularly. Do not use well water or softened water. Most well water contains a high softened water adds sodium. This can result in plants suddenly browning, or just not growing well. stored at the ambient temperature without exposure to sunlight. without exposure to sunlight. Garden Kit 5 1 2 4 3

Transcript of HYDROPONICS How to Raise and Lower the Lampshade GARDEN ...

Page 1: HYDROPONICS How to Raise and Lower the Lampshade GARDEN ...

HYDROPONICSGARDEN KIT Setup Guide

How to Raise and Lower the Lampshade

Operation procedure

Included in Package

tank or change water pump.3. Never operate garden kit if it has a damaged cord or plug, if it is not working properly, if it has been dropped and damaged, or if it has been dropped in water. If any of these conditions occur/exist, contact email:

5. This product is intended for household and resdential use only. Do not use outdoors.6. Do not allow water to contact hot LED Grow Lights.

water or other liquid to clean it.

directly submerged to water. If any water is spilled or scattered over

9. This appliance is not intended for use by persons (including children)

with the appliance.

pump.

1. Plug Adapter2. Sponges3. Basket Kit

To raise the Lampshade, press one hand around the bottom of the

hand. Push up to raise the Lampshade.To lower the Lampshade, press down the Lampshade with one hand.Tips: When planting a new seed pod kit, the Lampshade should be set to the lowest possible position.

Take out the lid of the water tank.Use tap water or bottled distilled water.

For best results, keep the water level between 4.5 liters and 5 liters.

water, shaking until well mixed.

water, shaking until well mixed.Add 25 milliliters A solution and 25 milliliter B solution when adding 5-liter water to the tank.

Note:

milliliter B solution.For best results, top off the water level in your garden regularly.Do not use well water or softened water. Most well water contains a high

softened water adds sodium. This can result in plants suddenly browning, or just not growing well.

stored at the ambient temperature without exposure to sunlight.

without exposure to sunlight.

Garden Kit

51 2 43

Page 2: HYDROPONICS How to Raise and Lower the Lampshade GARDEN ...

Control Panel Settings

Do not plug the adapter when no water in tank.You will hear a "Beep" sound after plugging the adapter, indicating that light panel can be controlled. If you hear no sound, pull out the panel

The basket lid help regulate moisture and temperature for optimal

take it off.

Large plants like Tomatoes and Peppers plant fewer than 7 pods to make room for the large plant size. Leave space between seed pods to allow room for each to spread out.

However, plants are impacted by temperature. Cold weather plants like -

Lower your plants, don’t raise your lights! You will achieve more compact,

closer to all plants.

Fast-growing plants (like Basil) make gardeners want to raise the

each individual plant at a time.

Plants compete for light. Left untended, more aggressive growers can actually block enough light to suppress growth of their slower-growing

automatically to provide your plants with “sunlight”, so you do NOT need

-tion.

Mode.Pressing and hold for 5 seconds, the light is

Cycle Timing:

automatically.)

Enjoy: Switch Light Mode by pressing 1 second.

Cycle Timing: Illuminate 12 hours/Day.

Grow/Pump Switch: Switch Light Mode by pressing 1 second. Pressing and hold for 5 seconds, switch pump mode.Cycle Timing: Illuminate 16 hours/Day. Cycle System of Pump: 12 hours - no pump2 hours - a repeating cycle of 5 minutes on, 30minutes off.

The garden kit does not include the seed.Choose the seed of a well-known brand at local.

Choose one seedling when the seeds grow into seedlings. More

Place Your Garden

Beyond the reach of children or pets.

window drafts, A/C vents, e.g.,).Indoor Garden Kit does not need additional light or a sunny window. In fact, too much direct sunlight can overheat your plants.

Lower your plants, don’t raise your lights! You will achieve more compact,

closer to all plants.

Fast-growing plants (like Basil) make gardeners want to raise the

each individual plant at a time.

Plants compete for light. Left untended, more aggressive growers can actually block enough light to suppress growth of their slower-growing

Page 3: HYDROPONICS How to Raise and Lower the Lampshade GARDEN ...

neighbors, and eventually they can die off due to lack of light. Spreading

herbs in a salad, soup on pizza or a sandwich. And, a full, bushy garden

LightsPlants love light! Always keep your Grow Lights as close to your plants

plants if possible.

PollinatingBecause most people don’t have bees in their home, you will need to

one or more of the following methods: Place an open hand inside plant branches and gently move your hand

Place a fan near your plants and the moving air will pollinate your plants.

1/3 of each individual plant at a time.

large leaves individually by cutting off at the base of the plant.

Cleaning pumpClean the cotton of the water pump at least once a month. You can take out the cotton from the pump to wash, and then replace it back.

the life of the pump.

After the plants bloom, change the water once a week to ensure that the potassium content is sufficient.

FCC

Too High

Cut Here

LeavesDiagram A Diagram B

FCC Statement

FCC Statement NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help with the supplied fastener. DO NOT hang the unit by the power cord.

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.

The manufacturer's warranty is void under the following circumstances but not limited to:• Improper or inadequate maintenance or modification.• Accident, misuse, abuse, contamination, or other external causes.• The use of unspecified adapter and accessories.• Loss or damage in transit.• Damages that occurs as a result of one's failure to follow the instructions.• This warranty does not apply to expendable or consumable parts and does not extend to any product from which the serial number has been removed.

team that guarantees hassle-free solutions to any issue you might have within the 24 business hours.

Tel: 1-(714)-714-2984

Email:

Web: https://idooworld.com

MADE IN CHINA

JOICOM CORPORATION 165 E. Freedom Ave., Anaheim,CA 92801

Shenzhen Runfeng Digital Technology Co., LTDChuanghui Building, Intersection of Banxuegang

neighbors, and eventually they can die off due to lack of light. Spreading

herbs in a salad, soup on pizza or a sandwich. And, a full, bushy garden