How to Install Ceramic Wall Tile125, Platinum Plaza,Judges Bungalow RoadBodakdev, Gujarat, Ahmedabad - 380054+91-079-40056230info@enticeworld.in

Ceramic Tile InfoYou probably know that ceramic tile is available in lots of sizes, all the way from 1 square inch - usually sold attached to sheets that are 12 inches by 12 inches - all the way up to 18 inches. They also come in a wide range of colors that can tie in with any dcor. However, you probably didn't know that all ceramic tiles don't resist water. In fact, some ceramic tile, called non-vitreous, will actually absorb water, so it should only be used in areas where it won't come in contact with water.

Preparing the WallCement backer board is actually made from a fiberglass mesh and Portland cement, so moisture won't bother it at all. It is available in 1/2 and 5/8-inch thick sheets (similar to drywall), and is usually sold in 32 or 36-inch wide panels 5 or 8 feet long. Cement board is cut the same way as ordinary drywall - score it with a utility knife and then snap it at the line. It's installed by screwing it to the underlying studs; place the screws about 6 inches apart and use special galvanized screws that won't rust.

Installing the TileStarting in the center, on one side of your reference line, apply a coat of tile setting adhesive to an area about 3' by 3' square. Take care not to cover your lines. Spread the adhesive with the smooth side of your notched trowel and then go over it with the notched side to create ridges in the adhesive.

Firmly press each tile in place and give it a slight twisting motion to be sure it makes good contact with the adhesive. As you work your way along, place tile spacers on all four sides of each tile, so your grout lines will be consistent. Take your time and work on the wall in three square foot sections.

GroutingAfter the tiles have all been installed and the adhesive has set up (probably overnight), it's time to grout the tiles. Depending on the width of your grout lines, you will need to choose either sanded or unsanded grout. If the spaces between the tiles are bigger than 1/8", use sanded grout. (Sanded grout actually contains sand particles that help make the grout joint stronger.)

Finishing TouchesLet the grout dry for a day and again buff away any grout haze that has appeared. If your wall is in a kitchen or bathroom, use a mildew resistant silicone caulk to seal the edges of the ceramic tile section where it meets the counter or top of the tub.

Contact US125, Platinum Plaza,Opp. IOC Petrol Pump Judges Bungalow Road, Bodakdev, Ahmedabad, Gujarat-380054http://www.enticeworld.in