for soil investigation - Geotoolgeotool.info/eng/pdf/LMSR.pdf · • Rigs • Tools • Accessories...

GEOTOOL • Rigs • Tools • Accessories • … for soil investigation

___________________________________________________________________________ Herne: Bahnhofstr. 148 D-44629 Herne Tel.: 02323 / 911.150 Fax: 02323 / 911.160

LMSR dynamic probing rig - the proven alternative for light, medium and heavy sounding in accordance to DIN 4094

LMSR - Dynamic probing rigs are available in different versions: LMSR-Vk with 4 stroke combustion engine foldable mast LMSR-Ek with electric motor for outdoor and indoor use foldable mast LMSR-Hk with hydraulic motor, Ex-proof for hazardous areas foldable mast SPT-V75k SPT (DPSH) version: please refer to EB01-50

below: LMSR- Vk (foldable) in transport condition

The rig can be transported manually on robust pneumatic-tyred wheels. At the probing point the mast is erected and is set up to the dead vertical position by means of two spindles and an air bubble level. Various rod systems according to local standards can be employed, a blow counter helps with taking the reading. The conversion to light (DP-L), medium (DP-M) or heavy (DP-H) dynamic probing procedures is quickly achieved by mounting or removing of additional drop weight bodies. The drop weight assembly is lifted by means of a rope winch with hand crank. For easy transportation in box-type vans, elevators etc. the foldable mast versions are recommendable. Also for WINDOW SAMPLING up to 80 mm ! Sampling is carried out by using window sampling tubes or slotted probing rods which are driven into the soil with the 50 kg drop weight at a drop height of 50 cm. For the extension the ordinary rods can be used.

Berlin: Wolfener Straße 32 D-12681 Berlin Tel.: 030 / 93666.033 Fax: 030 / 93666.036 E-Mail: [email protected] Internet: www.geotool.de



LMSR-Vk dynamic probing rig

for light (DP-L), medium (DP-M) and heavy (DP-H) dynamic sounding with Honda engine

This unit is powered by a reliable 4-stroke petrol engine which transmits ist revolutions through a centrifugal clutch and a robust gearbox to the rotating chain integrated in the mast body. Thus the unit is independent from other energy sources and can be operated everywhere. The number of blows per minute (between 15 and 30) is controlled by adjusting the engine speed at the throttle lever. TECHNICAL DATA: basic weight: ca. 125 kg total height: 2.340 mm width: 780 mm length: 785 mm rod/tool length: 1.200 mm max. to set up the mast vertically: lateral inclination 10 degrees frontal inclination 10 degrees blows per minute: 15 - 30, adjustable drop weight mass: basic weight 10 kg plus 20 kg 30 kg plus 20 kg 50 kg drop height: 500 mm Honda engine type GX100 aircooled 1-cylinder 4-stroke scope of supply:

unit ready to use, with rope winch, crank, drop weight assembly, drop weight bodies 10 + 20 + 20 kg, blow counter, air bubble level rod guiding pulleys and brass anvil piece for 22 or 32 mmrods, wooden base plates, toolkit rods, points or window sampling tubes not included

97 cm³ , 1,9 kW, leadfree fuel, 1,4 l fuel reservoir capacity,

noise level 75 dB(A) at 3600 RPM LMSR-Vk dynamic probing rig foldable mast, Honda engine article No.: 555112




LMSR-Ek dynamic probing rig

for light (DP-L), medium (DP-M) and heavy (DP-H) dynamic sounding with electric motor

This version is powered by a 110 or 230 Volt electric motor; apart from that it features the same technical layout as the LMSR-V units. A suitable power pack or power supply is required. TECHNICAL DATA: basic weight: ca. 125 kg total height: 2.340 mm width: 780 mm length: 785 mm rod/tool length: 1.200 mm max. to set up the mast vertically: lateral inclination 10 degrees frontal inclination 10 degrees blows per minute: ca. 25 drop weight mass: basic weight 10 kg plus 20 kg 30 kg plus 20 kg 50 kg drop height: 500 mm electric motor * AC motor, 110 V or 220 Volt 1,1 kW at 2810 RPM, 50 Hz

scope of supply:unit ready to use, with rope winch, crank, drop weight assembly, drop weight bodies 10 + 20 + 20 kg, blow counter, air bubble level rod guiding pulleys and brass anvil piece for 22 or 32 mm rods, wooden base plates, toolkit rods, points or window sampling tubes not included

* to be powered by a suitable power pack: 110 V, ca. 3,6 kVA LMSR-Ek dynamic probing rig foldable mast, electric motor article No.: 555212




LMSR-Hk dynamic probing rig

for light (DP-L), medium (DP-M) and heavy (DP-M) dynamic probing with hydraulic motor

This unit is powerded by a hydraulic motor and features the same specification as the preceeding LMSR-Vk units. The hydraulic drive motor can be run on a separate hydraulic power pack which at the same time serves to control the extraction jack for rod pulling operations. Vehicle pumps or other sources of hydraulic power can also be employed. A special advantage of this version is the fact that during rod change or similar the drop weight mechanism is lifted by hydraulic power instead of using a hand crank. TECHNICAL DATA:

Photo: LMSR-H, hydraulically drivenby a separate hydraulic pow er pack5/7 VZ w ith petrol engine (optional). The drop w eight assembly carries50kg here for DP-H (heavy) probingoperations.

basic weight: ca. 110 kg total height: 2.280 mm width: 780 mm length: 785 mm rod/tool length: 1.200 mm max. to set up the mast vertically: lateral inclination 10 degrees frontal inclination 10 degrees blows per minute: depending on

power source drop weight mass:

scope of supply:unit ready to use, with rope winch, crank, drop weight assembly, drop weight bodies 10 + 20 + 20 kg, blow counter, air bubble level, rod guiding pulleys and brass anvil piece for 22, 32 or 32 mm rod diameters, wooden base plates, toolkit hydraulic power source, rods, points or window sampling tubes not included

basic weight 10 kg plus 20 kg 30 kg plus 20 kg 50 kg drop height: 500 mm hydraulic motor to be powered by a suitable power pack: LMSR-Hk dynamic probing rig foldable mast, hydraulic motor article No.: 555312




LMSR-SPT/Vk DYNAMIC PROBING RIG (DPSH)

following SPT - standards This unit is driven by a Honda 4-stroke combustion engine which transmits ist power via a robust centrifugal clutch/gearbox system to the rotating lifting chain. Therefor the rig can be operated independent from other power sources. Blow rates from 15 to 25 blows pro Minute can be achieved by adjusting the throttle. The foldable mast allows for easy transport; one person can erect the unit through an optimal weight distribution. 3 crank jacks provide the possibility of setting the mast in the correct vertical position even under ondulated ground conditions and guarantee a stable standing position while working. Window sampling procedures up to 90 mm diameter can be effectively carried out without the need of folding back or moving the unit.

SPT - rig in working condition

TECHNICAL DATA: basic weight: ca. 135 kg overall height: ca. 2.600 mm width: 780 mm length: 785 mm working height: 1.200 mm to adjust the mast vertically: lateral angle +/- 10 degrees front/back angle +/- 10 degrees blow rate: 15 - 25 per minute/adjustable drop weights: basic weight 10 kg plus 20 kg 30 kg plus 20 kg 50 kg plus 13,5 kg 63,5kg drop: 750/500 mm Honda engine type GX100 air cooled 1-cylinder 4-stroke motor 97 cm³ , 1,9 kW , fuel tank capacity 1,4 l, lead free regular fuel noise level 75 dB(A) at 3.600 R.P.M. LMSR-SPT/Vk dynamic probing rig foldable mast, Honda engine article No.: 555412




LMSR-SPT/H DYNAMIC PROBING RIG (DPSH)

following SPT - standards This unit is equipped with a directly flanged hydraulic motor driven by a separate hydraulic power pack (optional). The folding mast allows for easy transport; one person can erect the unit through an optimal weight distribution. Three hand crank jacks provide the possibility of setting the mast in the correct vertical position even under unfavourable ground conditions. This Y-shaped foot guarantees a stable standing position during probing operations. Window sampling procedures up to 90 mm diameter can be effectively carried out without the need of folding back or moving the unit. TECHNICAL DATA:

SPT - rig in transport mode basic weight: ca. 130 kg overall height: ca. 2.600 mm width: 780 mm length: 785 mm working height: 1.200 mm to adjust the mast vertically: lateral angle +/- 10 degrees front/back angle +/- 10 degrees drop weights: basic weight 10 kg plus 20 kg 30 kg plus 20 kg 50 kg plus 13,5 kg 63,5kg drop: 750 mm (500 mm with optional drop height adaptor) LMSR-Hk SPT dynamic probing rig, folding mast, hydraulic motor: article No.: 555413




LMSR Dynamic Probing Rig

for light, medium and heavy dynamic probing (DP-L, DP-M, DP-H)

with Honda combustion engine, electric motor, or hydraulic motor

Dimensions

TECHNICAL DATA: total weight: 125 kg approx. drop weight: 10 / 30 / 50 kg height: 2.340 mm (2.280 mm) width: 780 mm length: 785 mm working length: 1.200 mm to set up the mast vertically lateral adjustment +/-10 degrees forward/ backward adjustment: +/-10 degrees Dimensions of unit with folded mast erected: as above folded: height: 1350 mm width: 780 mm length: 1400 mm




SPAREPARTLIST

You receive this illustrated substitute part list

free of charge at GEOTOOL under the item number

500000

LMSRRSGDPH


for soil investigation - Geotoolgeotool.info/eng/pdf/LMSR.pdf · • Rigs • Tools • Accessories...

Documents

Transcript of for soil investigation - Geotoolgeotool.info/eng/pdf/LMSR.pdf · • Rigs • Tools • Accessories...