Thermal etching of AlF3 and thermal atomic layer etching ...
Follow the standard procedures for moisture …...Follow the standard procedures for moisture...
Transcript of Follow the standard procedures for moisture …...Follow the standard procedures for moisture...
![Page 1: Follow the standard procedures for moisture …...Follow the standard procedures for moisture control, preparing root canal and try-in of the post. b.Selective-etching c.Total-etching](https://reader033.fdocuments.in/reader033/viewer/2022060404/5f0edab37e708231d4414340/html5/thumbnails/1.jpg)
3 4 5
6 7 8 9
2 Tooth Pretreatment1
Post Cementation and Core Build-up
*5 Refer to the Table 3 for light-curing time. *6 Leave PASTE more than 6 minutes
after light curing when the thickness of PASTE is greater than the specified curing depth.
*4 Refer to the Table 3 for light-curing time.
Flow Chart Sheet
When CLEARFILTM Universal Bond Quick and CLEARFILTM DC CORE PLUS are used for bonding and post cementation
*3 You must start Step within 1 min.
02/2017
DUAL-CURED CORE BUILD-UP MATERIAL
CLEARFILTM
DC CORE PLUS
CLEARFILTM
Universal Bond Quick
Legal product name Abbreviatedproduct name
Halogen10 seconds
20 seconds
1.5 mm
2 mm
10 seconds
20 seconds
1.5 mm
2 mm
Type Curing time Curing depth
LED
PASTE
BOND
Table 3 : Relationship between curing time and curing depth for each dental curing unit
Table 1 : Legal product name and abbreviated product name used in this sheet
1621 Sakazu, Kurashiki, Okayama 710-0801, Japan
Indications003 1561R360R
Follow the standard procedures for moisture control, preparing root canal and try-in of the post.
b.Selective-etching
c.Total-etching
Dry by blowing mild air, and paper point until BOND does not move*1
[1]
For Glass Fiber Post
Apply a phosphoric acid, rinse and dry
5sec.
Post PretreatmentChoose either etching procedure
[1]
For Metal Post
Blast with alumina powder, then ultrasonic clean and dry
a.Self-etching ( Move to Step )
10sec.
10sec.
Apply BOND with a rubbing motion Light-cure*2
Squeeze PASTE*3 Insert the post and light-cure PASTE*4
Place PASTE around the post
Light-cure PASTE*5,*6
from both the lingual and the labial (buccal) sides
Apply a phosphoric acid to the uncut and/or cut enamel, then rinse and dry
Apply a phosphoric acid to the entire cavity (enamel and dentin),then rinse and dry
*1 Use a vacuum aspirator to prevent BOND from scattering.
No waiting time5sec.+
[2 ] Apply BOND , then dry by blowing mild air
5sec.Dry
The effective wavelength range of each dental curing unit must be 400-515nm.
* Peak of emission spectrum:450-480nm
Table 2: Dental curing unit and curing time
Halogen
LED
Lightsource
Type
Halogenlamp
More than400 mW/cm2 10 seconds
10 seconds
5 seconds
800-1400 mW/cm2
More than1500 mW/cm2
BlueLED*
Light Intensity Light-curingtime
*2 Refer to the Table 2 for light-curing time.
3
7