Father’s Day Card

Instructions:

• Cut 4 ¼” x 11” Whisper White Thick cardstock, score in half and fold • To make suspenders, cut (2) 5 ½” x ½” strips of striped Flowers for

Every Season Designer Series Paper and adhere to front of card about 3/8” from each side

• Cut 6” x 1 ¾” piece of 2020-2022 Designer Series Paper (Cinnamon Cider) and make a pencil mark on bottom edge half way mark (3”)

• Fold 2 sides down to form collar, touching the points of the collar on the pencil mark

• Adhere collar to card front, matching top edges

• Cut 4 ¼” x 1 ¼” piece of Misty Moonlight from 2020-2022 In Color DSP and adhere to bottom edge of card

• To make belt, cut 5/8” x 4 ¼” AND 5/8” x 5/8” piece of Early Espresso cardstock and run through Big Shot using Old World Paper 3D Embossing Folder

• Adhere belt strip to pants • Cut ¾” x ¾” piece of Copper Foil Sheet and adhere to belt center using Dimensional • Adhere 5/8” x 5/8” Early Espresso cardstock to center of belt using Multipurpose Liquid Glue

• Punch Misty Moonlight DSP using Classic Label Punch • Snip this in half and adhere to jeans using Dimensionals • Add 3 Cinnamon Cider Enamel Dots to card front for buttons • Take a small fun-size bay of M&Ms and put a rubber band around the center • Cut 3/8” x 2” piece of Cinnamon Cider DSP • Adhere Tear and Tape to the back side of this piece • Wrap DSP strip around M&Ms on top of rubber band, securing it in the back • Adhere to card front using 2 Glue Dots