Mechanical Assembly Instruction

List of components:

1. 2 x 2’ Aluminum Tracks w/ Three legs2. 1 x 4’ Aluminum Tracks w/ 6 legs* (Note: This track can be separated into 2 x 2’ tracks by removing the center

locking mechanism)3. 4 Adjustable Billet Sensor assembly4. 2 Die Sensor assembly5. 4 x 100lb Strength Magnets6. 1 x ‘3 Aluminum Track w/ 2 legs7. 1 Mirror support/Sensor Fastener8. 1 Vertical Mirror post9.

<Insert image of parts>

Setup Instructions

1. First ensure the magnets are attached to the middle leg of the 2’ Aluminum Tracks to ensure secure locking between the shoe and the track.

2. Place tracks in desired location. Adjust tracks as necessary to be as parallel to the closest face of the die as possible.

WARNING: Make sure you do not have part of your body under or near the magnet prior to placing on the shoe. Severe Injury can occur due to the high strength of the magnet attracted to the shoe.

Acceptable Orientation Unacceptable Orientation

3. Once tracks are in place. Place Sensors onto tracks in general locations shown below.

Note: The 2 Die Sensors should be facing the match edge side of the die for accurate readings.

4. Once Sensors are in place, attach the mirror track to the one sensor using the Mirror support/Sensor Fastener

5. Place mirror post into designated slot along the mirror track.

6. Ensure Sensors are fastened in place and the system is secure.

7. Plug in harnesses to the back of each enclosure and plug other end into the Converter. Ensure harnesses are not in the way of operators.